Hi all: Veheicle: Jeep Grand Cherokee Laredo 1995 "Straight V6" Symtoms: I am driving and stopping at a red light, when the light turns green, I step on the gas, the engine would revs to between 3-4000 RPM for about 5 seconds and the car would lurch and act normally.

I am having problems removing part of my front driver's side hub assembly on my '91 Waggy. It's a Dana 44 6 lug without manual locking hubs. Here is a pic of the dealer schematic: http://www.brintsoft.com/dave/dealerSchematic.jpg

I've got a '99 Cherokee Sport with ~90k miles. I was recently driving in 4wd at around 80mph on a wet highway when I experienced a couple of bumps from somewhere in the drive train. It felt just like a hit some rough pavement, in fact that's what I initially thought had happened. I got out and...

My 98 TJ SE developed a bad coolant leak out a freeze plug in the head. When I pulled over to investigate, an awful brown liquid was steaming out of the block, I thought it was the head gasket. It was towed to the dealer Saturday, now I'm being told the coolant is bad and the freeze plugs and...

I park my CJ in one of those 10'x20' grey plastic garages, was out wheeling last sunday, and obviously I forgot to turn off lights, battery so dead not even a click, stuck camper battery in and on come lights. So question is, had CJ for 1 1/2 years, battery of unknown age, one of those ones with...

1997 ZJ 5.2. At startup, no oil pressure, can hear lifters clicking. Turn it off, turn it back on, oil pressure comes up, no lifter noise. Oil pressure is a little under 40 per the gage. Give it a little gas and at somewhere between 1000 and 1500 RPM the oil pressure goes away, no lifter noise.

Jeep(R) News & Events http://daimlerchrysler.bfi0.com/W3RT033318758671AD04632BA24450 The All New Jeep(R) Wrangler Unlimited and Patriot Born Leaders Dear RAMJ+W,

I was talking with a guy at the collision shop in Ingalls and he was tellin' me that the engine that is in my 98 Cherokee Sport was among the best engines ever designed and has been around in various iterations since the 60's. He lamented that Chrysler decided not to produce that engine any longer...

Gentlemen, I'm having some problems tracking this down. When I accelerate hard or get up to a certain RPM (about 3000) at cruising, I get popping coming out of my exhaust & a huge lack in power. The engine has never stalled, but I can't go any faster in that gear due to the misfiring. I've done...

Hi! It seems our 97 wrangler has developed the 'death wobble.' Occasionally, after i guess hitting a bump just right, we get a severe wobble in the steering wheel that will only stop after slowing down. I have checked linkages in the suspension, and the only play i can find is in the stabilizer...

Just rebuilt the Rochester SE2 carb on my '81 CJ5. It's the 151 engine commonly known as the "four banger". The bore is I have 5 hanging vacuum hoses and 7 tubes looking for hoses and no idea what goes where as all my marking have rubbed off. There is a vacuum hose routing diagram under the...

see http://concealedcarryforum.com/forum/topic.asp?TOPIC_ID=4585 -- Nathan In Montana http://ConcealedCarryForum.com http://1911talk.com http://HiPowerTalk.com http://GlockCarry.com http://p99sw99.com http://PPStalk.com

Just had my 86 cj7 (dana 44 rear) into my local jeep mechanic to replace my oil seal, bearing, retainer etc, and brake pad on the rear axle, driver's side. When I picked it up he mentioned that he had noticed a lot of play when he reinstalled the new axle - he guessed that a PO had spun a bearing....

Just replaced the battery in our 2001 Grand Cherokee. So, the orig battery was 2001, then replaced at 2006, now again at 2012. This would imply a general life of about 5 or 6 years. Since I was stranded in a Home Depot parking lot, and had a really hard time jumping the battery and then keeping...

Got the trans pulled out of my 89 YJ, now trying to remove the flywheel for surfacing. It doesn't show any signs of being burned, grooved, rutted, or pitted, however it is shiny. Does it need to be surfaced? Six 3/4" bolts hold the flywheel on, and the flywheel just cranks the engine over when I...

I'll start off by saying that this forum's archive can be a great technical resource -- most recently for me a crank sensor issue this past weekend....but the CJ5 misfire post reminded me of a doozie of a problem I had a few years back... Now, we've all got stories about breaking parts, getting...

I want to see how much emission legal power I can get out of my 258CI. Inline six with just bolt on parts. I will be doing that this last weekend in February 2005. Any one who has dealt with these modifications, any advice would be greatly appreciated, You can e mail me at Bolt on...

http://www.bloomberg.com/apps/news?pid=20601087&sid=aP11gqnZskmg&refer=home Selected highlights: <q> DaimlerChrysler AG may sell or seek partners for its unprofitable Chrysler division, abandoning its vision of building a successful carmaker that sold luxury Mercedes-Benz sedans as well as...

A while back I ask here about changing the differential gear ratio in my 2002 TJ, 4.0 (had installed a 4" lift and 33" tires, need to change gear ratio) It has been a while since messed with this , got married in there somewhere, and also lost the thread. Anyway I do remember that basically...

Hi, Got a 2001 Jeep Wrangler Sport with the 4.0 six cylinder engine. It's time to change the coolant but I want to know exactly what I'm getting into first. Everything that I have read about this procedure says to remove the coolant drain plug from the engine block. I have a factory service...