Well, as you can tell from the subject line I have problems. My exhuast valves seem to be sticking after my engine warms up producing a total power fall off and non stop backfires. Is there any hope of an engine flush doing any good or is this a total overhaul situation?? Leonard in Laredo (74...

One pair for sale fits bumper 56-71 with bow hole. Rechromed, real nice but not show quality. Selling pair for $60 + shipping. If interested, I'll email some photos so you can see what you're getting. Also, here's a list of other stuff for sale: Type 1 (Bug or Ghia): Bug Coat Hook 67-77 1...

I just got my engine running, the tube from the oil neck to the air intake was loose, and now I'm trying to replace the struts. I tried to remove the two bolts that secure the bottom of it, but they broke off. Since then, with it being a shoulder bolt, I have drilled it out, heated it up, broke...

I just got my engine running, the tube from the oil neck to the air intake was loose, and now I'm trying to replace the struts. I tried to remove the two bolts that secure the bottom of it, but they broke off. Since then, with it being a shoulder bolt, I have drilled it out, heated it up, broke...

We've just moved to Kentucky, USA, and would like to buy a Bug or Van (Type 1 or 2). Where is the best place to get a rust-free car? Is it possible to got to Mexico, where they were made until recently, to buy one and then drive it back here? Cheers, Marsh.

ok, whe i check my oil i smell gas mixed in... its a 1970 ve beetle, is that normal??? if not, what could be the problem??? Thanks for ur help!!!

Hi All, My '70 Bug has been acting up. It has been running fine until a couple of months ago when it shut off at a stop light. However, it started right back up. And drove fine for a few weeks. Then it happened again, and again, gradually getting closer and closer to eachother. The other day, I...

I'm re-building an old VW sandrail and am starting at the front end. It had been sitting for many, many years so all the rubber was toast. Things are going ok so far but I can't figure out how to pull the front torsion arms as they are tensioned by the spring in the beam. The bump stop won't...

I need a new single port intake for my 66 bug. Would I be OK buying the one that CIP1.com sells or should I keep looking for a clean original? DOes anybody have any experience with the aftermarket part? Thanks.

RECENTLY INSTALLED A PERTRONIX IGNITION IN OUR 1965 6V BEETLE. WHEN STARTER IS CRANKING IT WILL NOT START----BUT WHEN KEY IS RELEASED IT STARTS UP ----ANY IDEAS IT DOES HAVE A HARD START KIT INSTALLED--NOT SURE IF THIS HAS SOMETHING TO DO WITH THE PROBLEM.. CAR RUNS FINE AFTER IT GETS STARTED ...

http://www.digoliardi.net/65_bus_2.jpg Immaculate.

Why is everybody out to sell, sell ,SELL? instead of helping a longtime customer? I lost respect for the local vw parts house a few years ago when they insisted I'd be better off with one piece windows rather then re build my stock doors to combat leaks. Then I decided ok, they were ok for valve...

Hi Group, I have found a lovely Sapphire I 6V radio for my beetle but a need a mounting plate and rear hanging bracket to install it. Anyone got these bits sitting on a shelf ? Ta, - DM

Hello Group! As you may know, the original engine in my 1303 suffered from knocking bearings so I have bought a decent AR-code 1300 to replace it with. The original engine was an AR-code 1300 that a previous owner fitted 1641 barrels and pistons too, along with a progressive Weber, new heads and a...

Hello, Firstly, thanks for previous info offered on other subjects recently! They have been most helpful. I am wondering if putting full synthetic oil in the 1800cc aircooled bus will cause any problems with the old type eengine seals. It runs nicely now, and doesnt use oil, (dripping, or...

I recently got a new job and am looking to purchase a new, or used car to replace my 2002 Hyundai accent. I am looking for something good on gas (I will be driving about 1 hour each way), and some with good crash test ratings. I was thinking a Jetta TDI or some type of Subaru. I also want my car to...

Ok you guys have finally talked me into using the thermo and flaps, after 20 years of not having them at all,( I also drank the Koolaid about the svda,and that worked out well) this car i bought has them still installed, so i get the fan shroud back on and etc but no matter how low i get the...

Hi Jim. I went backwards on an url you posted to a .gif for a coil booster relay, and then came across a pic of you age 4 with a radio. Take a look at this and tell me what you think: http://www.shopatron.com/product/product_id=THK620219/272.0.256.0.0.0.0 Worth the price? A tad steep me thinks,...

Hi, Anyone know if Sam or someone at Rancho has an e-mail address? I live in South Africa and when I call the phone number from the web site, I can never get hold of anybody there. I think I am about 8 hours ahead. Can't call from home later! Thanks, Pete

Dear All, I came across a thread which mentioned potential problems with hazard warning/ indicator on the Passat TDi. I was having problems with indicators- worked intermittenly. It appears that is more of a common problem than I expceted. I removed the hazard warning switch...