|
|
Torque converter going bad? by
[email protected]
Hi all:
Veheicle: Jeep Grand Cherokee Laredo 1995 "Straight V6"
Symtoms: I am driving and stopping at a red light, when the light turns
green, I step
on the gas, the engine would revs to between 3-4000 RPM
for about 5 seconds
and the car would lurch and act normally.
( 1 2 3)
|
|
23 |
3,024 |
|
|
Hey Ya'll! by
Kate
Thought I would jump in and introduce myself.
I'm located in west Tennessee, only been here a couple of years though.
After about ten years of driving Mustangs traded off my 98 Cobra drop top
for a 2005 Liberty Limited 4x4 .
I traded in my California car for something more regionally correct.
The...
( 1 2 3 ... Last Page)
|
|
82 |
3,019 |
|
|
Jeep news from Chrysler by
Scott in Baltimore
Jeep(R)
News & Events
http://daimlerchrysler.bfi0.com/W3RT033318758671AD04632BA24450
The All New Jeep(R)
Wrangler Unlimited and Patriot
Born Leaders
Dear RAMJ+W,
( 1 2 3)
|
|
20 |
3,004 |
|
|
Weird oil pressure question by
J. Clarke[_2_]
1997 ZJ 5.2.
At startup, no oil pressure, can hear lifters clicking.
Turn it off, turn it back on, oil pressure comes up, no lifter noise.
Oil pressure is a little under 40 per the gage.
Give it a little gas and at somewhere between 1000 and 1500 RPM the oil
pressure goes away, no lifter noise.
( 1 2)
|
|
16 |
3,001 |
|
|
Recommendations for Jeep Mechanic near Edison, NJ by
[email protected]
I have a 99 Jeep grand cherokee (82 K miles) that has leak in the front
differential. I would like some recommendations for reliable and
reasonable Jeep mechanics around Edison or S Plainfield area in NJ.
Also are there any maitenance jobs that I have to get it done as I am
hit 80K miles?
Thanks...
|
|
1 |
2,997 |
|
|
98TJ Rotted freeze-plugs/Bad Antifreeze by
Mood
My 98 TJ SE developed a bad coolant leak out a freeze plug in the head.
When I pulled over to investigate, an awful brown liquid was steaming
out of the block, I thought it was the head gasket. It was towed to the
dealer Saturday, now I'm being told the coolant is bad and the freeze
plugs and...
( 1 2 3 ... Last Page)
|
|
36 |
2,995 |
|
|
91 Wagoneer Wheel bearing replacement problems by
Dave Milne
I am having problems removing part of my front driver's side hub assembly on
my '91 Waggy. It's a Dana 44 6 lug without manual locking hubs.
Here is a pic of the dealer schematic:
http://www.brintsoft.com/dave/dealerSchematic.jpg
( 1 2 3)
|
|
22 |
2,990 |
|
|
Cherokee transfer case forks broken by
[email protected]
I've got a '99 Cherokee Sport with ~90k miles. I was recently driving
in 4wd at around 80mph on a wet highway when I experienced a couple of
bumps from somewhere in the drive train. It felt just like a hit some
rough pavement, in fact that's what I initially thought had happened. I
got out and...
( 1 2 3 ... Last Page)
|
December 12th 04 11:52 PM
by Snow
|
30 |
2,987 |
|
|
xd-m first impressions by
Nathan W. Collier[_4_]
see http://concealedcarryforum.com/forum/topic.asp?TOPIC_ID=4585
--
Nathan In Montana
http://ConcealedCarryForum.com
http://1911talk.com
http://HiPowerTalk.com
http://GlockCarry.com
http://p99sw99.com
http://PPStalk.com
( 1 2 3)
|
|
28 |
2,985 |
|
|
death wobble!! by
Cal
Hi!
It seems our 97 wrangler has developed the 'death wobble.' Occasionally,
after i guess hitting a bump just right, we get a severe wobble in the
steering wheel that will only stop after slowing down. I have checked
linkages in the suspension, and the only play i can find is in the
stabilizer...
( 1 2 3 ... Last Page)
|
|
35 |
2,984 |
|
|
Cj5/151 with Rochester SE2. Need Vacuum Hose Diagram by
MStevens003
Just rebuilt the Rochester SE2 carb on my '81 CJ5. It's the 151 engine
commonly known as the "four banger". The bore is I have 5 hanging vacuum
hoses and 7 tubes looking for hoses and no idea what goes where as all my
marking have rubbed off. There is a vacuum hose routing diagram under the...
( 1 2)
|
|
15 |
2,973 |
|
|
new battery - about 5yrs by
ps56k[_3_]
Just replaced the battery in our 2001 Grand Cherokee.
So, the orig battery was 2001, then replaced at 2006, now again at 2012.
This would imply a general life of about 5 or 6 years.
Since I was stranded in a Home Depot parking lot,
and had a really hard time jumping the battery
and then keeping...
( 1 2)
|
|
12 |
2,972 |
|
|
What now?? (Clutch slave again) by
Eric
Ok, got the clutch slave in and installed it. Something just wasn't
right -- I couldn't get the fluid to flow from the master cyl through the
line and come out of the bleeder on the slave. Kept pushing the clutch in
and out until I had worked my way through 1.5 master cyl's worth of fluid.
STILL,...
( 1 2)
|
May 29th 05 06:38 AM
by Eric
|
11 |
2,971 |
|
|
How Many Miles? by
sam owens
I was talking with a guy at the collision shop in Ingalls and he was
tellin' me that the engine that is in my 98 Cherokee Sport was among
the best engines ever designed and has been around in various
iterations since the 60's. He lamented that Chrysler decided not to
produce that engine any longer...
( 1 2 3 ... Last Page)
|
|
67 |
2,965 |
|
|
Advice needed - recurring rear axle oil seal leak by
Deano
Just had my 86 cj7 (dana 44 rear) into my local jeep mechanic to
replace my oil seal, bearing, retainer etc, and brake pad on the rear
axle, driver's side. When I picked it up he mentioned that he had
noticed a lot of play when he reinstalled the new axle - he guessed
that a PO had spun a bearing....
( 1 2 3)
|
|
27 |
2,965 |
|
|
CJ5 misfires at high RPM/hard acceleration by
[email protected]
Gentlemen,
I'm having some problems tracking this down. When I accelerate hard
or get up to a certain RPM (about 3000) at cruising, I get popping
coming out of my exhaust & a huge lack in power. The engine has never
stalled, but I can't go any faster in that gear due to the misfiring.
I've done...
( 1 2 3 ... Last Page)
|
|
42 |
2,963 |
|
|
Mobile 1 Extended Performance by
Campbell C Freeman
I have been using Mobile 1 Synthetic Oil for years & was pleased to hear
about the introduction of Mobile 1 Extended Performance Synthetic. What I
found disturbing was that it does not meet API ILSAC GF-4 Certification
while Castrol Syntec does. I believe Mobile 1 SuperSyn does meet these
specs....
( 1 2 3 ... Last Page)
|
February 12th 05 12:01 AM
by Tom T
|
33 |
2,957 |
|
|
Jeep Forum by
[email protected]
Hey Guys and Gals
I've started a jeep forum at http://www.kloozen.com. I'm having a hard
time getting people to post messages though. If anyone has some spare
time and doesn't mind posting a question or comment it would be greatly
appreciated. My intention is not to take users from this newsgroup...
( 1 2 3 ... Last Page)
|
September 15th 05 04:52 AM
by bllsht
|
41 |
2,948 |
|
|
Can't find the coolant drain plug??? by
Dennis[_2_]
Hi, Got a 2001 Jeep Wrangler Sport with the 4.0 six cylinder engine. It's
time to change the coolant but I want to know exactly what I'm getting into
first. Everything that I have read about this procedure says to remove the
coolant drain plug from the engine block. I have a factory service...
( 1 2 3 ... Last Page)
|
|
33 |
2,940 |
|
|
Flywheel removal by
Carl Saiyed
Got the trans pulled out of my 89 YJ, now trying to remove the flywheel for
surfacing. It doesn't show any signs of being burned, grooved, rutted, or
pitted, however it is shiny. Does it need to be surfaced?
Six 3/4" bolts hold the flywheel on, and the flywheel just cranks the engine
over when I...
( 1 2 3 ... Last Page)
|
|
43 |
2,938 |