A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Jeep Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Views Reverse Sort Order
Thank you Veterans. by L.W.(ßill) Hughes III
Thank you Veterans: http://www.billhughes.com/Veterans.htm God Bless America, Bill O|||||||O
(Multi-page thread 1 2 3 ... Last Page)
November 15th 05 11:05 AM
by Eric Go to last post
44 2,452
Well finally it's gotten back to normal in r.a.m.j+w by Didier
Now that that loud mouth jerk off Bill has disappeared. Any other -ex- Jeepers in here? Several years back I traded in my 93 Cherokee for a Subaru and never looked back. Best deal I ever made. Of course, if McCain wins the presidency, I may have to move to Canada once and for all, but hopefully...
(Multi-page thread 1 2 3 ... Last Page)
August 25th 08 12:04 PM
by Snarky Go to last post
56 2,447
There sure are a lot of useless people posting junk in this newsgroup. by Socks
Holly **** man! I could name all the ****ING USELESS people posting crap that has nothing to do with Jeeps... But I would be here for hours! What's wrong with people these days? Ryan Heibloem Richmond,B.C. CANADA
(Multi-page thread 1 2 3 ... Last Page)
August 7th 07 06:08 AM
by L.W. \(Bill\) Hughes III[_1083_] Go to last post
63 2,444
2000 Jeep down-grade driving by Bryan Ross
I have an automatic 3 speed transmission in my 2000 jeep wrangler (4.0) . When driving down-hill it seems to speed up even when the grade is not changing. My 99 Mountaineer holds back better in first gear than my jeep. I had it diagnosed, but nothing showed up as being a problem. Has anyone else...
December 1st 04 08:54 PM
by Matt Go to last post
6 2,435
1996 jeep cherokee rear brakes lock up by Sevenday61
1996 Jeep Cherokee, 4.0L, manual trans, no ABS. the rear brakes were locking up, noticed that the park cables were not fully releasing and the drums were oversized. Replaced the park cables, shoes and drums, they worked great for about 2 days and are now locking up again, sometimes just a little,...
April 16th 15 04:38 AM
by DougW[_6_] Go to last post
1 2,431
Jeep CRD in Massachusetts by googleposter
All, Do any of you very smart people know if there is a way I can own (and drive!) a Jeep Liberty CRD in Massachusetts. -- gp
(Multi-page thread 1 2 3)
September 7th 05 04:25 PM
by Tom Greening Go to last post
20 2,431
OT - Struts by Ben
I was getting the oil changed in my Saturn at this tire shop and I was told by the Tech that the struts where shot and they were shredding the tires.. I have never heard of that before... Can someone help me on that one? I know it isn't a Jeep question, but I thought that the shredding tire thing...
(Multi-page thread 1 2 3 ... Last Page)
March 15th 05 10:43 PM
by Jeff Strickland Go to last post
31 2,429
minor transmission trouble by [email protected]
When upshifting my transmission, it grinds in going from 1st gear to 2nd gear about 90% of the time, unless I double clutch, in which case there are no problems. I do not have any problems when upshifting to other gears, or when downshifting to any gear. Additionally, when the temperature...
September 14th 15 09:29 AM
by [email protected] Go to last post
4 2,427
Ethanol in Grand Cherokee by Chris Lamb
Have 2000 GC V-8 and wondering if anyone is running ethanol in theirs. Price here in WI is 45 cents a gallon cheaper than 87 Octane.
(Multi-page thread 1 2 3 ... Last Page)
February 16th 06 02:45 PM
by Vito Go to last post
57 2,410
Multiple fuel pump failures by Retiredff
'89 YJ/ 258 313,000+ miles (re-man motor 11,000+ miles) Over the last few years, I have had several fuel pumps fail. I just replaced one that failed yesterday, which replaced one from July '07, which replaced one from Oct. '06, etc. So far, they have always failed at start-up, so no problems...
(Multi-page thread 1 2 3 ... Last Page)
November 26th 07 03:38 AM
by L.W. \(Bill\) Hughes III[_9132_] Go to last post
58 2,407
getting ready to order by [email protected]
im getting ready to order my next rubicon and im having a little trouble deciding on options this time. i know i want the auto for crawling and cruise control for the long commutes. were i cant make up my mind is: -half or full doors. i never much cared for the hard top on my last rubicon and...
(Multi-page thread 1 2)
December 26th 04 01:55 AM
by twaldron Go to last post
14 2,404
Jeep Wrangler High Idle Problem by 97tjMike
Hello Everyone: I have a 97 TJ and 95% of the time it idles perfectly. However, about 5% of the time, usually when the vehicle has been run for more than 20 minutes or so, the idle in neutral or park will shoot up to between 1200 and 1500 RPM. The only way to get it to stop is to put the vehicle...
(Multi-page thread 1 2)
August 18th 07 07:23 AM
by DougW[_2_] Go to last post
17 2,399
OT - Politically Correct Bull**** by Dave Milne
http://news.bbc.co.uk/1/hi/england/west_yorkshire/4305798.stm Apparently, prison officers having an English flag on a tie-pin given as a result of a donation to a cancer charity, is to be banned in Wakefield as "It could be misinterpreted as a racist symbol". The Chief inspector for prisons, Anne...
(Multi-page thread 1 2 3 ... Last Page)
October 11th 05 11:04 AM
by Fidelio Go to last post
38 2,398
Help diagnose this noise 2 by jeepeeyes
Hi group, I own a 2000 Jeep Wrangler 4.0 Automatic with about 70K miles on it. After a period of driving at slightly heavier than normal engine load on hot days, a knocking sound starts coming from the engine compartment. I think that the noise I've been experiencing is most likely coming from...
September 18th 06 03:23 AM
by philthy Go to last post
8 2,393
What tools do I need to replace a U-joint? by [email protected]
My 2002 wrangler x is making an awful noise when in 4wd. Its kinda like a grinding/torquing metal sound with some pops here and there. A buddy of mine said it really sounded like a bad u-joint. My brother listened to it and said he head it coming from the front passenger wheel. So basically I...
(Multi-page thread 1 2 3 ... Last Page)
August 6th 07 11:50 AM
by L.W. \(Bill\) Hughes III[_1003_] Go to last post
51 2,391
TJ not returning to center after turn by 97tjMike
I have a 1997 TJ Sport with power steering. I posted this question a while ago but never really got an answer. The problem is that the steering wheel does not *completely* return to center after a turn. It attempts to, but never completely bounces back. Also, when driving straight down the road,...
(Multi-page thread 1 2 3)
August 27th 07 01:37 PM
by Bill Spiliotopoulos Go to last post
20 2,390
95 Jeep Wrangler Shifting problems by [email protected]
Hello gentlemen I'm hoping somebody can give some insight to a problem that started about a month ago...I have a 95 wrangler 4.0 5-speed manual transmission with 105K and all of the sudden the clutch is sticking in gear sometimes (mostly first) amd sometimes I can't get into gear unless I let up on...
(Multi-page thread 1 2)
January 21st 05 06:56 PM
by Jeepster Go to last post
12 2,390
1988 Jeep Comanche clutch hydraulic fluid ? by ctops
I just got this Jeep I was told the clutch was just replaced , I can see the master cylinder is new , the fluid was dirty so I drained it out and replaced it I was told that Dot 3 brake fluid was fine by the NAPA guy, now my clutch works but makes a "rattling sound" when fully engaged , tried...
(Multi-page thread 1 2 3 ... Last Page)
April 6th 05 09:35 PM
by L.W.(ßill) Hughes III Go to last post
40 2,371
Diode (?) in heater resistor pack by Pat Moore
We're working on a friend's "new" 94 Cherokee and have replaced the busted heater fan motor. We then tracked why the fan only worked on "High" to an open component in the heater resistor. It's shown as a switch in the wiring diagram, and physically resembles a silicon diode. Shorting across...
(Multi-page thread 1 2)
January 4th 05 11:07 PM
by DougW Go to last post
12 2,352
ball hitch with extra long shank by asdf asdf
does there exist a ball hitch receiver with a very long shank, like 14" or more? i'm not referring to the overall length, but just the length of the shank tube that has the receiver pin holes. thanks
(Multi-page thread 1 2 3)
October 27th 05 11:56 PM
by Sarge Go to last post
20 2,351
Post New Thread


Display Options
Showing threads 321 to 340 of 8867
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 06:05 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.