|
|
old dry fiberglass? by
Keith Bennett
A few years ago I picked up a wrecked 73. I replaced all the damaged
bodyparts with aftermarket panels and had it painted. It's been my daily
driver for three years, but now the paint is peeling on most of the
origional body panels in a big way. Since I am going to have to go through
it again...
|
February 17th 06 03:40 PM
by Dad
|
2 |
438 |
|
|
01 C5 Service Active Handling Soon - warning by
aRKay
I had a "Service Active Handling Soon" DIC warning and it cleared itself
overnight. Two days later I had the same warning so I took it to the
dealer. My car is still covered by GMPP. By the time I got to the
dealer the warning disappeared. They ran some checks and said there may
have been...
( 1 2 3)
|
February 17th 06 05:10 AM
by PJ
|
21 |
1,436 |
|
|
Service Engine Soon light C4 by
[email protected]
Bob Katts wrote:
> I have a slightly loose cowl on top of the radiator (funky little rivet-
> type connector loose) that sometimes, on startup, jiggles the O2 sensor
> going into the engine from that point, according to a mechanic. Will this
> Service Engine light find its way off by itself at some...
|
February 16th 06 06:50 PM
by PJ
|
1 |
570 |
|
|
Grocery lists by
WayneC
Weekly Grocery Lists for Ennis Del Mar and Jack Twist,
Summer 1963, Brokeback Mountain
WEEK ONE
Beans
Bacon
Coffee
Whiskey
WEEK TWO
|
February 15th 06 06:39 PM
by WayneC
|
2 |
575 |
|
|
Anti-theft horn 1980 C3 by
BART FITZPATRICK
Can anyone tell me were the anti-theft horn is at and how to deactivate the system until I find the problem? I went to open my car door today and the alarm kept going off and the only way to stop the horn from waking the neighbors was to disconnect the battery. I have disconnected two horns up...
|
|
7 |
421 |
|
|
Building a Corvette Kit Car by
Ironman
This is just a reality check for myself on the costs and time to build
a Corvette Kit car. My thoughts fall in line with the absolute out of
reach costs of buying a genuine classic late 50s Corvette versus
building a late 50s style Kit Corvette. I also want to have the
advantage of new technology...
|
February 14th 06 10:17 PM
by E_Tar
|
8 |
1,387 |
|
|
Ric, can you explain this?? by
Dad
....I guess you would have had to see the movie.
Weekly Grocery Lists for Ennis Del Mar and Jack Twist,
Summer 1963, Brokeback Mountain
WEEK ONE
Beans
Bacon
Coffee
Whiskey
|
|
1 |
575 |
|
|
Service Engine Soon light C4 by
'Key
"Bob Katts" > wrote in message
...
>I have a slightly loose cowl on top of the radiator (funky
>little rivet-
> type connector loose) that sometimes, on startup, jiggles
> the O2 sensor
> going into the engine from that point,...
|
February 14th 06 04:24 AM
by 'Key
|
1 |
518 |
|
|
Does anyone have a ProCharger installation ? by
dave
Upon investigation for an LS2 , it appears that an ATI ProCharger is the
way to go for a SC using an air to air intercooler. If anyone has one,
how loud are they under boost ? Any problems ? What type of oil do they
take ? Opinions ?
Thanks, Dave
|
|
9 |
518 |
|
|
Remove/Replace Power Brake Unit Help by
Gary B. Golden
Attempting to remove and replace the power brake unit on a 1981 automatic.
GM shop manual simply says remove nuts from 4 studs on firewall. Yeah,
right. How do you get to them? I can see them and if I wiggle my fingers
just right, I can touch them. I know they're 14mm but can't get to them
with...
|
|
2 |
395 |
|
|
80 Vette/Headlights/Left Light won't Close by
douglas9
Have 1980 whose headlights open and operate correctly, but when i
attempt to turn off/close lights the left light will not close. By
blowing compressed air into the vacum line i can close the light.
Should i just replace the actuator or might it be something else. Any
help appreciated.
|
|
3 |
440 |
|
|
LF: 1953-55 Corvette parts by
Eugene Blanchard
I'm looking for (LF) C1 specifically 53-55 Corvette exterior and interior
parts such as a grille, stainless, dash, etc.. If you have any parts,
please contact me.
Thanks
|
|
0 |
473 |
|
|
Dash lights by
E_Tar
The dash lights in my C3 stingray ('77) are very dull at night time.
I tried using the light plunger knob to brighten them, but it doesn't
help..
are the gauges in the center and the tach and speedometer back lights
powered by the same light ? a bit confused i am.
How do I change it or make them...
|
February 13th 06 03:16 AM
by BDragon
|
5 |
552 |
|
|
What's A Good Deal On a New Z06? by
dave
'I took it to a shop with a very good reputation today. The only
problems was it needed a new tentioner, both belts replaced and the
coolant reseviour was leaking and needed to be changed. Plus it was time
for an oil change and a radiator flush. All that cost me $575. They
couldn't find anything...
|
February 12th 06 01:49 PM
by dave
|
0 |
503 |
|
|
C5 "mode" switch light by
Pappy
On my '01, I just noticed that the "mode" switch on the heater control is
dark at night.
Am I wrong, or was this lighted at one time?
If so, can I replace the bulb/LED? How do you do it?
TIA
Pappy
|
February 12th 06 12:31 PM
by sbright
|
1 |
449 |
|
|
|
February 12th 06 04:46 AM
by Alex
|
0 |
478 |
|
|
Problems, thoughts, advice from any 2006 owners ? by
dave
'What a great price. That's almost a robbery,or as some would say,
better than how the steelers won the super bowl. I've been pricing on
the chevy website and without any options other than the added price for
blue and the auto trans, it's coming in at around 44 grand. How'd you
pull it off. I'm...
|
February 12th 06 02:45 AM
by dave
|
0 |
599 |
|
|
sold my lt4 today by
rebco10
I am kind of sad. Sold my second c4 in 8 years. My first 93 was ok.
It was a convertible. The car I sold today is a 96 glass top wioth 20
thousand miles.. It was a great car. I guess someone that drove a c4
then a c5 would say the c5 is no comparison better. But owning a
convertible c4 then...
|
February 11th 06 08:56 PM
by rebco10
|
0 |
667 |
|
|
Problems, thoughts, advice from any 2006 owners ? by
dave
I hope to have my new Vette in the driveway by tomorrow. Got a super
deal from a dealer in Michigan : 2006 LS2 base coupe package (LT1) ,
manual 6 speed, 8 miles on the odometer, Targa top , for $40,070 plus
tax and plates. Didnt want any of the options really --- going to put
the dollars into a...
|
|
1 |
569 |
|
|
Determine production date from vin by
keithdesselle
Here is a chart from an earlier posting. Maybe this will be able to
help.
1 G 1 A Y 8 7 6 4 B S 420
1 2 3 4 5 6 7 8 9 0 1 2
1st digit: Country of origin: 1 = USA, 2 = Canada.
2nd digit: G = General Motors
3rd digit: Division, 1 = Chevrolet.
|
|
0 |
338 |