|
|
High temp gauge drops when braking? by
Romer
This one has me stumped.
I got a 1992 Ford Explorer 4.0 4x4 and automatic.
I replaced my intake manifold gasket (upper and lower) this weekend
and when we got everything back together, the engine ran fine, no
leaks, sounded good. But when we started it up the temp gauge was way
over. Then we...
|
February 6th 07 10:04 PM
by Darby
|
3 |
451 |
|
|
can anyone tell me what this red flashing key is? by
John Bryan
BlankIve had a 2000 explorer for 9 months and have just tonight noticed a
red flashing key in a circle symbol flashing on the dashboard? any ideas???
bet its something gay, that i should already be aware of, and now im going
to look like an arse :)
Thanks,
|
|
2 |
451 |
|
|
Procedure to replace inlet manifold o ring on 99 explorer 4.0l SOHC ? by
KTM
Reading through many posts I have come to the conclusion that this
gasket/o ring is bad in my wifes car. When it is cold the car revs up
when started and then dies to almost a stall, then revs back up then
back to just above a stall. I have cleaned the IAC and that does not
seem to make a...
|
November 30th 05 09:52 PM
by KTM
|
4 |
451 |
|
|
Mach Display Problem by
Alex
I have a '99 Ford Explorer with the Mach sound system. For the last 3 years the display has been blank. About once every 6 months, usually during a major weather change, the display comes back and stays on for a few hours. I have looked all over for an explanation and noticed many articles that...
|
January 28th 06 02:41 AM
by Jim
|
2 |
451 |
|
|
2000 Explorer - check engine by
partsmore
Check engine light - sets code:
lean burn - bank #2
02 sensor
--
only when <-10 degrees
clear code and runs fine.
Which sensor needs changed?
|
|
1 |
450 |
|
|
2004 Ford Explorer towing by
db
We just bought a 2004 ford explorer. I don't believe it has the towing
package because it has the class II receiver on it. Is it possible to
still get the towing package that would have come with the vehicle
when it was new. My understanding is you get the 3.73 axel ratio
instead of the 3.55 axle...
|
March 4th 07 10:19 PM
by db
|
2 |
450 |
|
|
|
|
1 |
450 |
|
|
Explorer Belt Noise by
[email protected]
I have a 1998 Ford Explorer. When the engine is idling, the engine area
eventually starts to produce a load droning sound, perhaps from a belt.
It has seemed to have started up since the weather started getting
warmer (central florida). I have had this in the past. I mentioned it
to the dealer a...
|
May 3rd 06 06:23 PM
by dan
|
2 |
450 |
|
|
1994 Ford Explorer Alarm System by
[email protected]
Hey all. I have recently bought a 1994 Ford Explorer XLT Limited. The
previous owner didn't provide the owner's manual and knew nothing about
the existing alarm system. It appears that the alarm system is factory
installed and uses a remote which is programmed by, among other things,
shorting a...
|
December 15th 05 02:44 AM
by domingo
|
4 |
450 |
|
|
Dashboard Paint Scuff - Help Please by
Len Krauss
My '96 Explorer has a tan colored dashboard. While carting some supplies, I
managed to get it scuffed in a few places on the air bag panel above the
glove box, resulting in what appears to be a greyish vinyl background
showing through. There are no gouges to speak of -- it looks like just...
|
|
3 |
450 |
|
|
Air Filter Intake by
midas
Vehicle is a '98 V6 SOHC. Want to covert the stock air box to a universal
air filter(K&N). The mass air flow sensor has a 3 inch opening. Have seen
samples online and they used a 3 inch filter attatched to the sensor. Is
there such a way; Can this be done? Or have to use an actual aftermarket
air...
|
July 3rd 05 09:27 AM
by ob1
|
1 |
450 |
|
|
1999 4.0 OHV gauge goes to hot and steadys out about midway by
Lance
All,
I have a 1999 Explorer 4.0 OHV. Mileage is around 135,000. Had the heads
replaced around 120,000. Both heads had a fine crack. This was done about
14 months ago.
Fast forward to 3-20-08. While driving the Explorer after it had been
sitting for a few hours and engine was cold, the temp...
|
April 2nd 08 01:37 PM
by Lance
|
2 |
449 |
|
|
94 Explorer A/C Clutch not operating by
Deanesfield
Hi
I have noticed that my A?C clutch doesnt operate when required
I have put a meter across the plug and get no reading - I have check
the fuses
Is there a relay I should check or is this serious ??
Regards
|
|
7 |
449 |
|
|
How long before code P0455... by
Nerdlinger
comes back on MIL if the problem wasn't fixed correctly? The guy I took
my 96 Explorer 4.0 to said I had cracked hose at the component near the
left front headlight (purge solenoid?) so he cut off cracked piece and
reattached. It looks like a molded L shaped end piece on the hose and
doesn't appear...
|
|
0 |
449 |
|
|
Explorer Alignment by
Jack[_4_]
I think I remember a thread last year on front-end alignment which
mentioned a company which offered technically advanced alignment which
exceeded all others.
I have not been able to find such a thread in the archive.
Does anyone have such info to relay?
Jack
|
November 11th 06 02:54 AM
by oklaman
|
4 |
449 |
|
|
Front differential leak by
Jonah
My 2001 XLT 4x4 has a slight drip from the front differential cover. I have 2 questions: Is a gasket required or can I
use something like RTV or Form-a-Gasket? What's the correct fluid to use in the diff for refilling?
Thanks for the help.
|
October 3rd 05 07:39 PM
by Jonah
|
0 |
449 |
|
|
99 ford explorer air bags sensors by
HOK
My girlfriend lost control of the suv and hit a tree almost center of
the suv. Bumper of the suv is badly damaged and the hood of the vehicle
buckled. she did have her seat belt on , thank god! she has some
bruises, but other than that she was ok. probably in shock. The vehicle
was assest by a...
|
|
1 |
449 |
|
|
03 Explorer - Looking for a new stereo by
Martini
OK, I have a 2003 Explorer EB.
This vehicle has the 6 disk CD w/ Sub, Rear Seat DVD, and the steering wheel
controls.
I'm thinking of upgrading the head unit. I'm looking for a stereo model that
would still interface with the DVD and the steering wheel controls as well
as the sub. I would like it...
|
|
0 |
449 |
|
|
1994 Ranger Fuse Box schematic by
Ispyu
Does anyone have a schematic or description of the fuse locations for a
1994 Ford Ranger XLT. I am too cheap to go buy a manual and want to
know if that year had a factory cruise control. I have been told mine
is an aftermarket and it is not working so I am chasing the possibility
that a fuse may...
|
June 21st 06 12:03 AM
by Ispyu
|
2 |
448 |
|
|
Visor Sticker Removal Help by
Big Shoe
Has anyone tried to remove the stickers from the visors? If so, what
did you try and how did it work out? I am tired of seeing those
stickers all over my visors and would like to take them off.
|
November 15th 05 01:05 PM
by Roadie
|
6 |
448 |