Hey Everyone, I'm replacing the seals and bearings in my CJ8 this week. It's already got a Superior one-piece kit. I have the axles out of the housing, bearings and seals are pulled. I have a friend with a press who can handle the bearings and retainers. Thig is, where can i get the retainers? ...

Hi, I want to replace my stock 97TJ (manual trans) radiator with a BeCool unit, but am completely confused with what I need to buy. i.e. there is a huge range of part numbers, with some different websites claiming different specs for the same part number. What I need is a drop-in replacement for...

http://cid-2087c8668312d90f.skydrive.live.com/browse.aspx/.res/2087C8668312D90F!827 http://cid-2087c8668312d90f.skydrive.live.com/browse.aspx/.res/2087C8668312D90F!808 The links are to my new bumpers I fabricated over the past two weekends. Made from 3 inch x 4 inch x 3 eights structural steel.

Hi all, I'm doing a T-4/5 to T-176 upgrade on my '82 Scrambler, and I noticed that the bellcrank plastic bushings are shattered again. I replaced them less than a year ago, and I've done no serious off-roading, just some very bumpy mountain roads. I've got new polyurethane bushings all round...

Hello group and thanks in advance for any help. This is more of a general automotive question but I figured you folks would be the ones to ask. I have a '98 Wrangler and occasionally it makes a squeaking sound like a belt or pulley is going bad. The volt meter also drops to nothing. The serp. belt...

I guess this is really a general question, not vehicle specific. But, I'm asking in regards to my 96 Cherokee. How do I check or know if the tension is correct on the serpentine belt? I think I over-tighten it and end up wrecking the water pump bearings/pulley. tia, Mel P.

Removed belt, replaced idler pulley, got belt most of the way back on but cannot find how to loosen automatic belt tensioner so I can get the @#$%^&* belt back on all pulleys. Anybody got any ideas?

Or the continuing saga of the hiccuping '89 XJ. I got the new ICM installed and it didn't help a bit. 30 seconds after first start after the install and the durn thing died. Oh, it did restart ... after sitting for an hour, so I double checked everything ... except fuel rail pressure. So I let...

Are there shops that can fix a bent axle yoke, or is a whole new axle needed? The axle yoke is the fixed yoke that the steering knuckle mounts on. This is a 2003 Rubicon.

After an Early AM Fender-bender,... As near as I can see damage is minimal but part has been hard to locate on-line today. Vehicle: 1997 Green TJ Sahara Part Needed : Left Front Fender Flare & Side Light. (Wiring looks OK).

What are the best wiper blades for my Jeep ? Is there a preferred brand ? Thanks !! James

I know about ARB but I'm sure there are others out there and I'm looking to find them. Respond to this posting or email me by reoving the "REMOVE". Thanks SB

best business . JUST DO IT . http://www.eucarwash.ten.lt

Hi, I own a 98 TJ and because of my 33 tires aren't legal for street use, I need to replace my stock fender flares. My question is which one must I buy: Bestop, Bushwacker, ...? Appreciate any help. Mike

http://www.u-dominion.com/?r=72383 Check it out!

GPS systems are utilized as hand held devices, can be found as a feature on cell phones, and can be mounted in cars... http://travelsguide.googlepages.com/auto_or_handheld_gps

I want to add a hitch to my '01 XJ, more for the accessories I can add that utilize the receiver than for actual towing. At most I may end up towing a small trailer for my motorcycle. Still I figured a class 3 would be the way to go since it's the most popular size. Any brands you guys would...

Frequently the dealers everywhere from the world have chosen import Japanese used cars business due to trustworthiness and the reliability in Performance of Used Japanese cars. For more information and details contact us: TEL +81-48-791-3945 FAX +81-48-791-3946 E-mail: Best...

So now my teardown is complete and the body and frame are out to sand blasting I need to decide on a lift kit. I have a 93 YJ that will be intended for mostly beach driving and some off-road. I live in PA so I will be somewhat limited in my trails. My question is do I go with a body or suspension...

Folks, I just purchased a 1959 CJ5 jeep and would like to get some recommendations on best repair/maintenance manuals to purchase. I see various manuals by a number of different companies. Also if you have any preferred parts suppliers who you have had good luck with, I'd like to hear that...