|
|
GT500 by
Robert A. Plourde Jr.
So, I am driving to work this morning and I see, 'mustang legend lives' on a
flashing sign up ahead.
I get to where the sign is and I see a 2007 Shelby GT500 in red with white
stripes on the lot.
Now, this isn't a Ford dealership but a small used car dealership.
Here is their web page asking...
|
|
3 |
731 |
|
|
How to replace speedo cable on 65 4-speed by
[email protected]
Hi all,
The speedometer needle on my 65 jumps around all over the place and
doesn't go over about 30 mph. This cluter is out of a 66. I replaced
the speedo with the original "long" 65 speedo. No luck, same deal. So,
I have surmised that the cable must be the culprit. I know that I can
get a new...
|
|
3 |
366 |
|
|
Winter Rims by
GILL
Joe Dubovec wrote:
> I have 2003 Mustang with 16" alum. wheels.
>
> Would like to get 15" steel rims. For snow tires.
>
> Can someone tell me what would fit.
>
> I called couple of wreckers they said they don't have anything.
> But don't tell me what would fit.
>
|
|
3 |
317 |
|
|
2005 GT Rear View Mirror Removal---any ideas before I start? by
Nylon Lover
Replacing my old (no auto dimmiming) one with a AutoDimming with
Compass/Temp model this week and like to know if this has been done by
any 2005 GT Owners with success. I had a good friend crack his
windshield and don't want to do thae same mistake. I seached the web
but no directions are...
|
|
3 |
414 |
|
|
|
|
3 |
816 |
|
|
Interchangeable Parts by
Joe Colella
To illustrate the reason for my question below, I have learned that the A/C
compressor on an 82-86 Capri, 82-93 Mustang, 84-86 LTD, 85 Marquis, 85-88
Cougar and 85-88 Thunderbird are all interchangeable.
Is there a book or manual (either in print, online or on CD-ROM) that lists
interchangeable...
|
September 20th 06 08:02 AM
by russ
|
3 |
570 |
|
|
electrical 1990 Ford Mustang GT 5.0 by
[email protected]
I thought I had a dying battery. The car would intermitently not
start. Now won't start at all. Mirror lights only go on dimly and
when igitiion is turned on mirror lights go out completely. I replaced
battery and pos cable that was deteriorated. Any additional advice on
what to check...
|
|
3 |
530 |
|
|
Ford, toilet-bound by
[email protected]
Advertising to homosexuals (does Ford think they actually make up 10%
of the population like they claim and not the 2-3% Statistics Canada
found??), sissy ads touting safety and they continue to ass-rape their
Canadian buyers.
New GT500 cost? $50-$55K Can. That's $45-$50K U.S.
Ford is making a...
|
|
3 |
318 |
|
|
Edelbrock 1806 tuning guide by
Mark C.
I bought a '69 Mach 1 with an Edelbrock avs thunder series 650 cfm
carburator #1806. I need to tune it but I don't have the guide. Can someone
please email me a copy of the tuning graph with the corresponding rod and
jet chart. I was hoping Edelbrock had a PDF of this but no luck. Thanks in...
|
|
3 |
2,082 |
|
|
As Promised::: My GT vs V6 Test drive :::::: by
Paul[_2_]
at 20 Aug 2006, Terry Brannigan
wrote in :
According to my local dealer the 'Pony Package' consists of the grille,
fancier mats and doorsils as well as special striping. Also in order
for it to be applied you have to have the ABS+TCS package installed....
|
|
3 |
280 |
|
|
1990 Mustang GT a/c and turn signals not working correctly by
[email protected]
I have a 1990 Mustang GT and I recently took it in to have the heater
core replaced (worst labor rip off ever, 9 hours) and when I got my car
back, all of a sudden the turn signals and the fan/air conditioning has
stopped working. At first I though, oh they just blew a fuse and
iddn't replace it...
|
|
3 |
294 |
|
|
Two Questions about a 72 Mach 1 by
nospam
Hi Group,
I'm restoring a 72 Mach 1 which has a urethane front bumper. I'm having a
very difficult time trying to get the big phillips screws out of the bottom
of the bumper so the I can remove it. I've tried PB Blaster, but no luck so
far. I can't use heat because of the urethane. Anyone have...
|
|
3 |
288 |
|
|
2005 Mustang Dash Removal by
[email protected]
I need to install a FM Modulator behind the radio. Anyone able to lend
some pointers on removing the dash to gain access? I had a helluva
time on my 2000 mustang and want to avoid that fiasco with this car.
Thanks in advance,
Adam
|
|
3 |
186 |
|
|
Merkur Xr4ti engine into a 2.3L 1990 Mustang? by
[email protected]
Hi, a buddy of mine is giving me his engine, as he wrecked his old
Merkur. I'm looking to throw the turbocharged 2.3 L SOHC into my car,
and I'm not finding too much info on this project. If anyone's had any
experience with this, is there anything I should know about? From what
I understand, this...
|
|
3 |
250 |
|
|
How to disconnect speedometer cable in a 69 Mustang? by
Steve[_9_]
I am removing the instrument cluster on a 69 Mustang to do some
restoration work. I have all the screws out and the wiring harness
disconnected, does anyone know how to disconnect the speedometer cable
from the back of the speedometer?
|
|
3 |
488 |
|
|
87 Mustang 5.0 Stalls when Hot by
gantone1
When hot my 87 Mustang 5.0 will buck and stall. Normally it will
'restart' before engine dies completely. WHen this occurs the tach
drops to 0 RPM even though the engine is still turning (but with no
power). Because the tach drops so fast my guess is that the problem is
ignition or electric...
|
|
3 |
329 |
|
|
A tad off topic re 1986 F-150 by
Dave Combs
My son in Colorado has an old F-150 which he is trying to get started so his
step son can drive. He put in a new battery today and it started. Then he
turned it off and tried to start it again but no go. In fact no juice re
lights, etc. He's about 30 miles from the nearest mechanic. Any...
|
August 10th 06 12:13 AM
by nospam
|
3 |
270 |
|
|
Cheap "tuneup" things to help with emissions? by
Cameron
Hey all! I am so close to passing my emissions I think all I need now is a
regular tune up.
I'm looking for very cheap things I can do that I have left out of my tune
up list:
oil change
spark plugs/wires
check/set timing
fuel injector cleaner (do I need this if I ran the "Guaranteed not to...
|
August 8th 06 08:00 PM
by Jeff H
|
3 |
972 |
|
|
tires and wheels by
Robert A. Plourde Jr.
I am wondering what sizes of tires and wheels people are using on their
Mustangs for the rear?
I have a 2002 GT Vert with the stock wheels, and Eibach Pro-Kit lowering
springs.
I am wondering if I get the 17X10.5 inch rims from Mustang Tuning, with the
Sumitomo 315/35/17 tires if they will fit...
|
|
3 |
424 |
|
|
390 big block wheels by
Seybertron
does anybody know what are the original wheels to go with the 1968 390
big blocks? I have a project car that I'm working on and I'm having
trouble finding the correct wheels. Thanks
|
|
3 |
355 |