Does anyone know how the heat control plunger is supposed to work in a '62 Willys wagon? The cable moves through a bracket on the engine side of the firewall but isn't attached to anything. The other two controls are (1) heat/defrost and (2) fan speed/fresh air flapper valve and work...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=004&sspagename=STRK%3AMESE%3AIT&viewitem=&item=140231079340&rd=1

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=004&sspagename=STRK%3AMESE%3AIT&viewitem=&item=140227169642&rd=1

Nice body, interior little dry all complete with stuck 327 auto And factory air only surface rust in Montana asking $1000 can ship 406-660-0115 Phil

Check out what I found just now! http://memphis.craigslist.org/car/291713027.html

The listings that I've found for FS Jeep pickup repair panels (front fenders, fender wells, floor) end at 1974. Was there a significant design change in `74? Or will those parts fit earlier models with minor revision?

A co-worker of mine had to clean up his storage area recently, and had to get rid of this. The body is in 1/2 way decent condition. It has Buick's 225-V6 in it. The transmission, transfer case, and driveshafts are missing (no clue as to they're where-abouts). I have no interest in trying to put...

Just inserted a rebuilt 360 into my 75 Jeep Cherokee. Started up great; except oil jets out of the top of the oil filter at the rate of about a pint a second. My suspicion is that the oil pressure relief valve is not opening. What accentuates my suspicion is that the previous build did not have...

I recently purchaed a new fuel tank for my 76 CJ5 and once it arrived I realized that it had a 2.25" filler neck and my filler tube was more like 1". I installed the tank because i was sure it was the right one adn I would be able to locate to orriginal filler tube but to no avail. Does anyone know...

Help needed I have a 1977 CJ5 jeep with a V8 and stock rear end. The rear differental failed and was replaced with a spool by previous owner now I am putting a differental back in to the rear end and could use any information on installation and set up.

1977 Jeep J-10 Parts for Sale Drive shafts, front and rear. Yokes. Weather stripping, the felt that the door windows runs up and down in.. Door Handles inside and out. Window cranks. Door latches. Arm rest Clock. Under dash AC unit. Gauges. Ash tray. Tilt wheel assemble and cruise control...

My friend's CJ-5 has some pretty sloppy steering. I installed a new borgeson steering shaft for him and that helped, but it didn't eliminate slop. There's still a good 2" of play at the steering wheel before the wheels move. Tie Rods, Ball joints, etc are all good. So I tried the steering...

Hello, A friend has a 1978 J10 pickup with driver's side window off track or busted loose - not sure exactly yet. I'm looking for any diagrams or photos of the guts of this door before we go in to assess the repair, so we can reconstruct things. Or point me to a good data and/or parts...

We have tried everything we can think of to no avail or brakes either. Are there any common problems we may be over looking? I can say that the pedal seems OK until the right rear bleeder is opened. Please any help would be great. Sue

While riding down the mountain this morning, this Jeep shut off two times. It cranked right back up. When I got to the bottom of the mountain, but still rolling downhill, it shut off a third time. I came to a complete stop , and it took several minutes for it to crank back up. I let it run...

Hey all, Haven't posted on here in ages since the death of my '86 CJ7's engine. I'm looking into an '80 CJ5 today with the 4.2L I6 engine. It's been rolled on the highway and has some hood/windshield damage. Haven't looked at it yet but the engine is said to run fine and the frame would pass...

I have a 1980 CJ5, 4 speed, Dana 30 in the front, AMC 20 in the rear. I think the Jeep had a 6 cylinder in it to begin with but now has a 304. This is the problem... When you pour the coal to the Jeep it makes a treibble sound coming from the back end of the Jeep. Sounds like a chain drive...

I recently purchased a 1980 CJ7. Motor is a straight 4, pretty sure 2.5, this was uncommon and probably wolnt be staying for long as I am in the process of finding and rebuild a 305 or 350. Does anyone know what kind of transmission, transfer case, front end and rear end it has in it. I have looked...

I have a 1980 Jeep CJ-5. I recently learned that my cigarette lighter is not working. It is not getting voltage. In the same week, I found that my interior lights (underneath the dash) do not work. I replaced the bulbs, just to make sure. These are the lights that turn on when you...

Hey all. I've been on an internet journey trying to find the proper paint color for my 1981 CJ7. I busted the windshield and windshield frame last trip to Hollister, so now its time to paint the new windshield frame as well as my hood. The paint is stock. It is a burgundy orange color. My...