A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Mustang Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
88 5.0 failed emmisions. by Cameron
Hey all! You probably have been seeing all my recent posts about the use 88 5.0 with t-tops that I just bought. I took it today to get the emmisions tested and failed (Tennessee). HC: 1446 (max allowable 220) CO: 2.35 (max allowable 1.20) I emailed the guy I bought it from and asked him if he...
(Multi-page thread 1 2 3)
August 15th 06 09:34 AM
by KEITH MCCUMBER Go to last post
28 1,230
88 coupe dynoed tuned yesterday!!!!! by IsellJeeps
280 at the rear wheels with gt 40 heads gt 40 intake trickflow stage 1 cam pulleys cold air roller rockers 373's offroad pipe no cats with flowmasters 155 fuel pump 180n thermostat advanced timing (next mod the turbonater LOL).... added subframes last night & strut tower brace now just need 2...
September 13th 05 02:32 PM
by IsellJeeps Go to last post
9 462
88 coupe gone by J. Sprauer
well the 88 coupe ive been building for a year is gone..... kind of sad but what the heck... It went to a good home... back to the Jeep group!!!!!!!!!! Jarod
March 13th 06 02:28 PM
by Old Ford Go to last post
3 351
88 GT Cam help by [email protected]
I have a stock 88 Mustang GT with AOD trans. Can I put an F303 cam in the engine with no other modifications?
May 20th 06 05:39 PM
by fordlvr Go to last post
2 319
88 GT Convertible - Restore Info. by 88 Mustang GT Conv.
Ok...I got flack on the regular ford NG for posting this in a manner which didn't use the correct lingo so here it goes... I have a 1988 Mustang GT Convertible and live in the Ottawa area. I'm looking for general information about restoring the car to showroom like condition with some modification...
October 29th 07 03:09 AM
by biggus Go to last post
3 532
88 GT Oil Pump? by akheel
Here are the symptons: Ticking noise started low and then grew louder and louder until it was very loud. Sounds like something in the valve train is slapping around pretty bad, car seems to run OK otherwise, although I shut it down as soon as I was able. Meanwhile, oil presure gauge not...
August 10th 08 07:37 PM
by elaich[_3_] Go to last post
1 368
88 GT starter removal by akheel
Anyone know who to remove the upper bolt on the starter on an 88 Mustang GT (auto, convertible if that matters)? Can't seem to get any wrench or combo of sockets and extensions on it so that I can swing the wrench or the ratchet. Tried using long extensions and coming out the front, but the...
September 14th 08 12:01 PM
by akheel Go to last post
0 359
88 Mustang by Kevin P. Degan
My son has a 88 Mustang with 5.0 and 5spd. What happens is that when he shifts into 2nd it acts like it want to stall. It only acts up in 2nd. he read some where about this happens it may be the fuel pump. any help would be appreciated. Also anybody know where to get a good service manual. Thanks
June 15th 05 07:30 AM
by Ashton Crusher Go to last post
1 199
88 Mustang GT Fuel Filter location... by [email protected]
I want to replace the fuel filter on my 88 GT and was wondering where is the filter located???
(Multi-page thread 1 2)
June 7th 07 04:00 AM
by Chumley Go to last post
14 683
88 Mustang GT Help by [email protected]
I have an 88 Mustang GT 5-speed and it is not running right at all. It is like it is overloading. You can smell fuel real bad through the exhaust. When you rev it up really high it will back fire and it is also missing. I've changed the fuel pump which I had to anyway and I've also changed the...
August 28th 06 11:10 PM
by nospam Go to last post
4 213
88 mustang radio install - no sound! by Ree-Yees
Hey all! I've done a few google group searches and I am a bit confused as to my problem, but I think I am getting closer to the solution. I have a cd player, 88 mustang, and a wiring harness from walmart. When it is all hooked up the radio comes on just fine but no sound comes out of the...
February 14th 06 06:51 AM
by android32 Go to last post
7 432
88' mustang gt- alternator wiring by [email protected]
I've replaced my alternator on my 88' 5.0 mustang, along with the clip that goes on top of it, but the problem I am having is that 3 wires go into that clip, 1 skinny wire and two other wires. The two wires have the same rubber coating on them (black with a skinny orange stripe). I'm worried that...
March 31st 08 06:39 AM
by Schmedly Go to last post
1 424
89 2.3L engine swap by sneaky_0ne
I have a 89 2.3L mustang. whats is needed to swap ina 5.0L? besides the motor, computer rearend brakes. exhaust. fuel lines?? do the spindles need to be change?
November 22nd 04 12:15 AM
by Backyard Mechanic Go to last post
1 808
89 4-cyl; no power at low RPM by dalemstevens
Problem: Car has little power at low RPM, but as the RPMs climb the power is fine. Its almost like one should rev the engine before letting out on the clutch in order to get the car to take off from a stand still. Any ideas what could be the problem? Background: I've been helping a friend get his...
May 11th 08 12:51 PM
by dwight[_3_] Go to last post
5 518
89 5.0 dies at stop lights by Brian Bunin
This may be similar to some things that were posted recently, but I'll go ahead and ask anyways.... Had the 89 Mustang (Automatic) out today and had something odd happen. Every time I approached a stoplight and hit the brakes to gently slow down, the engine would die very quietly around 5 mph....
April 30th 06 05:14 PM
by Backyard Mechanic Go to last post
6 261
89 5.0 GT Conv Power Windows by Brian Bunin
The Drivers side front window does not want to go down. I'd rather not tear the door apart, if it's just the switch, but I can't seem to make heads or tails of the switch panel. Is there a wiring diagram out there anywhere? Neither the Chiltons, nor the Haynes manuals cover it.
April 12th 06 10:43 PM
by Brian Bunin Go to last post
4 715
89 5.0 mod prob, take your pic! by [email protected]
89 GT 5.0 5 spd Just installed Trick Flow heads and cam. BBK SSI intake, fuel regulator,cold air intake, Pro-M Racing MAF, Ford Racing 24lb fuel injectors, yes ordered MAF to match. Just got her together, she fired right up for timing, but wouldnt idle, started her 2-3 times, kept her going with...
May 7th 08 01:51 AM
by biggus[_2_] Go to last post
4 490
89 5.0 tires by Howard Nelson
Have 89 5.0 with stock rims. Need 225/60/15 tires. Haven't replaced recently and that size is getting a little hard to find. Looking for H rated in 60-90 dollar range. What in group member's experience are decent tires available now. Last ones I got were Michelin Pilots but currently Costco will...
June 6th 07 10:02 PM
by /\\rtful ]\)odger Go to last post
7 378
89 95 rearend by [email protected]
does a 95 gt rear have the same number of axle splines as a 89 gt. will my four lug axles be alright to use in the 95 rear
October 31st 07 04:28 AM
by RD Jones Go to last post
2 249
89 Audio Question by Jim C[_2_]
If there's anyone out there who can answer this, they're on this list... I have an 89 convertible, my third Fox - body. My others were a 92 and 93. The later models have a speaker grill in the back seat trim panel, but my 89 doesn't. It actually has an 'indent' set up like an arm rest. I have...
April 29th 08 02:37 AM
by Ironrod Go to last post
3 424
Post New Thread


Display Options
Showing threads 1021 to 1040 of 6222
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 08:32 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.