A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Jeep Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
YJ seats??? by [email protected][_1_]
I am new to Jeep and need some help on some things. First of all, will late 90's TJ front seatsf it into my 94 YJ on the existing brackets? Also, I seem to get conflicting answers about the front seats of my YJ. Some say none had retractable seat backs and some say all did. Not even my local Jeep...
(Multi-page thread 1 2)
January 26th 07 08:05 AM
by Mike chambers Go to last post
10 894
new clutch problem by [email protected]
...just finished installing a new clutch on my 85 cj7 /amc 150 4popper. Now the clutch won't disengage...I bled the hydraulic clutch system...I'm sure I put the disc on properly...the only way i could get it to work was to use a 6 inch socket extender in place of the slave cylinder push rod. It's...
(Multi-page thread 1 2)
April 2nd 07 03:29 PM
by [email protected] Go to last post
10 595
Wheel cleaning by jerryg
Greetings. I just purchased a set of Aluminum wheels from a friend. They are from his 98 Sahara, stock rims. The ones with the five hole pattern. I will be putting them on my 95 Sahara. I think it's gunna look really nice! Anywho my question is, what is the best way to clean them. They have some...
(Multi-page thread 1 2)
April 2nd 07 09:11 PM
by Kate Go to last post
10 405
amc 20 dana 44 replacement by Deniz
Hi guys, I'm from Turkey and i have 79 cj5. Recently i have replaced my amc 20 with a dana 44. But some vibrations occured both while accelerating and decelerating probably because of the rear driveshaft.It's a bit difficult to find parts for cjs in Turkey, i need to have some parts made customly....
(Multi-page thread 1 2)
April 5th 07 04:12 PM
by Earle Horton[_16_] Go to last post
10 996
GC check engine trouble by John in Vegas
I have a 98 GC, 4.0 auto. The check engine light came on ant the code is P0720, output shaft speed sensor circuit. I got part # 1-04800879 (the sensor). Can somebody who has the factory shop manual scan me the troubleshooting/repair steps for this code. The light has been on for a long time,...
(Multi-page thread 1 2)
April 15th 07 01:09 AM
by John in Vegas Go to last post
10 631
Cross Country Directory Of Jeepsters by Rickster the Jeepster
Is there any sort of cross country available list, by city & state of Jeep enthusiasts available to assist someone have problems with their Jeep?
(Multi-page thread 1 2)
April 13th 07 11:47 PM
by billy ray Go to last post
10 604
Rotate tires on 2006 Liberty by Barry Bean
My 2006 Liberty has a tire pressure monitoring system. Do I need to do anything different when rotating tires? -- Ask Me Why I support Stem Cell Research http://stemcells.nih.gov/info/faqs.asp
(Multi-page thread 1 2)
April 23rd 07 01:24 PM
by Kate Go to last post
10 712
Don't Race Me by Jon[_8_]
Hello Fellow Jeepsters, Warm weather is upon us (at least in New England) and the new tight-as- a-drum soft top is gently billowing! If you may remember, I had a PS pump replaced a few short weeks ago, and upon pickup noticed the check engine light was on, followed by high revving startups,...
(Multi-page thread 1 2)
April 26th 07 06:52 PM
by Jeff Strickland Go to last post
10 584
weird rotor wear on '96 GC by maleemi
I was rotating my tires this weekend ('96 GC Laredo 6cyl 134k miles)and noticed that the front passenger brake pads were completely worn and the brake rotor was HEAVILY scored. The drivers side front brakes and rotor was in good shape with about 3/16" of wear left on the pads. What would make...
(Multi-page thread 1 2)
June 6th 07 10:35 PM
by DougW Go to last post
10 649
Towing a Jayco 1406 Camper with a YJ 4.0L by Dwayne
It's that time of the year when we pull out our campers and get them ready for some spring camping. I've been pulling my camper with a Ford F-250 and have had no problems. I have recently sold the Ford and plan to use my Jeep Wrangler as the tow vehicle. For those who are not familiar with the...
(Multi-page thread 1 2)
March 22nd 07 10:43 PM
by L.W. \(Bill\) Hughes III Go to last post
10 560
Fixing exhaust lead by nrs
The rearmost stud is broken on my 2.5 4cyl (95 YJ) and it has an exhaust leak. It was this way when I bought it so I have no idea how long it has gone like this. Yesterday I took it to a mechanic and he said that he could just remove the manifolds and broken stud and put in a new gasket but that...
(Multi-page thread 1 2)
March 16th 07 05:16 PM
by nrs Go to last post
10 584
Blown Speaker 99XJ by Kevin in Iowa
This is a strange one, I get a rattle when music is playing (not loud) all of the sudden on the drivers side door, it almost sounds like a rattle in the dash, but when I move the fader over to the passenger side, the rattle goes away. So I thought I would see if it was the tweeter that was making...
(Multi-page thread 1 2)
February 24th 07 09:55 PM
by philthy[_1_] Go to last post
10 553
Full door Soft Top.. by agent99
Im still looking for a Full door SoftTop for my 94 Wrangler.. black, grey, spice, but I also need the hardware with it...
(Multi-page thread 1 2)
February 15th 07 01:44 AM
by twaldron Go to last post
10 858
Clutch? by jbjeep
I need to replace the clutch in my TJ. Any recommendations for good aftermarket brands? I need something strong that will hold up for another 8-9 years! Thanks. -jenn
(Multi-page thread 1 2)
February 13th 07 04:19 AM
by c[_1_] Go to last post
10 583
1996 YJ Half door to 2002 TJ conversion by [email protected]
My buddy gave me his old set of Greenish 1996 Half doors and soft uppers. They need work. Especially the soft uppers. When i try them to see the fit, it seems the angle is off a bit. Looks like the door is 1.5 " too low on closing. How easy is it to re-do the hinges and will the 1996 fit a 2002...
(Multi-page thread 1 2)
February 10th 07 10:00 AM
by Scott in Baltimore Go to last post
10 498
My absense... by Outatime
Just a quick note to explain my absense. I met a girl who drives an '02 Grand Cherokee, and we've become the best of friends. Had it not been for our mutual interest in Jeeps, it may not have happened. We're off to the Sierra's this weekend to play in the snow in the TJL. (She's nervous...
(Multi-page thread 1 2)
February 11th 07 11:15 PM
by billy ray Go to last post
10 618
Steering Knuckle installed and functioning! by Dave[_29_]
On a cold and blistery Michigan night, I spent last night putting my TJ's front right steering knuckle back together, after having to drill out a broken caliper bolt. . and I just had to ask, how many others have forgot to install the spash-guard after bolting down the 3 hub- bolts. . . .oops. . ....
(Multi-page thread 1 2)
February 23rd 07 09:18 PM
by Dave[_29_] Go to last post
10 1,078
Towing question. by Brett
On TJ unlimiteds, why is the automatics tow rating bumped to 3500 but not the standard? I have an 06 Rubicon Unlimited manual and would like to pull a pop-up trailer that needs the 3500 rating. thanks, brett
(Multi-page thread 1 2)
March 3rd 07 08:20 PM
by Carl S Go to last post
10 544
Rear Main Oil Seal by Edward R. Wojciechowski JR
I have a '96 GC 4.0 with 170k and it looks like the seal is starting to leak. I was wondering if there was a good web site to go to for instructions on replacing this before it's to late. Thanks in advance..
(Multi-page thread 1 2)
March 15th 07 03:52 AM
by Lon Go to last post
10 1,416
Is this a good deal? by griffin
'98 TJ 4cyl 2.5L 78,000km 5spd Hardtop Completely stock $9000 CDN
(Multi-page thread 1 2)
June 19th 07 02:15 AM
by Clint[_4_] Go to last post
10 958
Post New Thread


Display Options
Showing threads 2121 to 2140 of 8867
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:24 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.