A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Jeep Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
1998 Cherokee XJ Air Con Problem by [email protected]
Hi, I have a 1998 face lift Cherokee, and the Air con does nothing, now it's possible that it needs re-gassing, but there seems to be no change in engine noise when I turn the dial to one of the A/C settings, and I would at least expect the condenser load to show as a blip in RPM or something,...
(Multi-page thread 1 2)
June 13th 06 02:59 AM
by Earle Horton Go to last post
11 1,783
Jeep 4.0L with Rubicon tires (30.6") and 4.56 ok? by kion
I Have a 2005 TJ with 4.0L and 3.07 with 30.6 tires, in my next upgrade i'm installing a detroit locker on the rear axle and a True Track in the front axle with 4.56 Gears? What are your experience with this setup? I'm specially concerned about the gear ratio, since i'm not very sure weather to...
(Multi-page thread 1 2)
August 16th 06 04:19 AM
by L.W.(Bill) Hughes III[_1_] Go to last post
11 907
Purchasing replacement electrical connectors? by Nick Hughes
Hi Folks, I had a few electrical connectors melt on my 2000 Jeep TJ. Specifically, the headlamp dimmer and A/C control connectors. Does anyone know if you can purchase these separate instead of the WHOLE wiring harness? Also any tools that might be involed to crimp the wires into the...
(Multi-page thread 1 2)
August 29th 06 05:01 AM
by Nick Hughes Go to last post
11 1,141
Replacing Lighter Socket? 2000 Jeep TJ by Nick Hughes
Hi Folks, My lighter socket is having connection problems. I'm assuming some sort of oxidation of the hot tip is playing a role. Has anyone replaced one? I'm able to turn it in circles, but can't figure out how to remove it from it's dash unit. Insight much appreciated. Thanks,
(Multi-page thread 1 2)
August 30th 06 04:11 AM
by [email protected] Go to last post
11 826
Had to put the back seat in today... by Kate[_3_]
We had to go up to the attic and drag the back seat out today and put it back in the Jeep. It's been out since I got it. My daughter has decided that Tennessee is where she wants to be and is moving back, with my little grandson Nick. he's three years old. I talked to him on the phone and he...
(Multi-page thread 1 2)
September 7th 06 11:06 PM
by Kate[_3_] Go to last post
11 1,012
change oil brands.. by Cal[_1_]
How does the group feel about changing oil brands? I have a 97 GC, 150,000 miles. I have used havoline 10/30 every 3000 to 4000 miles since i have had this jeep. I have a friend that changed from havoline 10/30 to valvoline 10/30 full synthetic, and his 4 cylinder sounds like a different...
(Multi-page thread 1 2)
September 24th 06 08:46 PM
by Earle Horton[_5_] Go to last post
11 749
Rubicon Front Locker by Don Hamilton[_1_]
I just purchased a 2005 Jeep Rubicon Unlimited and when I push the button to lock the wheels the rears quit flashing for full lock but the fronts continue to flash only. I was in some sandy dirt and when cornering the front would occasionally also stop flashing momentarily. Is this normal? Do I...
(Multi-page thread 1 2)
October 12th 06 02:53 AM
by mabar Go to last post
11 734
Rear main seal by JohanB
Hey........... Looking for some advice My rear main seal started leaking and I noticed they sell 2 types A 1 lip or 2 lip seal. Can I use both or do I have to install a 1 lip if it has a 1 lip
(Multi-page thread 1 2)
October 9th 06 03:01 PM
by DougW Go to last post
11 1,287
New Jeep! by Carl[_3_]
I finally have a Jeep again! 2000 XJ. It's green, 4.0, aw4, np 242. 93,000 miles. In good shape for a good price! Pics to come soon. Carl
(Multi-page thread 1 2)
October 27th 06 02:12 AM
by Kate[_3_] Go to last post
11 493
360 wristpin oilers by Unknown[_1_]
I got my rods back with new pistons on 'em, but if I orient the dots on the piston top to face the front of the engine then the oil notches on the rods face downward throughout the complete rotation of the crank (rather than towards the wristpins). That can't be right, can it? I seem to...
(Multi-page thread 1 2)
August 7th 06 03:09 AM
by billy ray Go to last post
11 867
Remote Entry - 95 Grand Cherokee by Mike1977
Hey There, I recently bought a 95 Jeep Grand Cherokee, but it didn't come with a remote key entry. I am just wondering if I can buy some remote from eBay.Can anyone please advice if this will work? I didn't get a user manual, so I am completely lost.
(Multi-page thread 1 2)
August 28th 06 08:00 PM
by TF Go to last post
11 733
Front Axle U Joint Question by Ed Wojciechowski
I have a '96 GC, 4.0 with 165k on it and I need to replace the driver side U joint. How difficult is it and any suggestions on how to do it would be greatly appreciated.
(Multi-page thread 1 2)
June 16th 06 08:43 PM
by DougW Go to last post
11 833
Michelin v. BFG AT K/O tires for 2000 JGC ??? by James
I have a 2000 Jeep Grand Cherokee, with Michelin Radial X, Cross Terrain SUV tires. They have been great tires for me. On a prior 1988 Jeep Cherokee, I had the Michelin XC LT4, and they did well too, but I think they were a bit louder on the road. My tire size is 245/ 70 / R...
(Multi-page thread 1 2)
June 19th 06 06:59 AM
by Jeff Olsen Go to last post
11 734
Need help with a problem by [email protected]
I have a TJ jeep 6cly 4.0L 2002. When I drive the jeep for around 1/2 then make a sharp turn it seems like the wheel binds and I have a flat tire. This only occurs if the jeep has been driven for 20 minutes or longer. If I take it for a spin around the block it is ok. The U-Joints are find, and...
(Multi-page thread 1 2)
June 20th 06 11:43 PM
by Mike Romain Go to last post
11 712
Paint for side bars by Dennis
Have a Jeep Wrangler with the nurf bars starting to rust. They are originally painted with a black powder coat. If I repaint them, what would be the best type of paint to use? I was thinking of using an epoxy primer with acrylic enamel. Any opinions? Also is there any way of removing the plastic...
(Multi-page thread 1 2)
June 28th 06 04:51 AM
by Matt Macchiarolo Go to last post
11 591
93 Grand Cherokee Power Window by D
Hi All, The window went down in the driver door and wont go back up. Power to it okay. Is there a web site that shows picks of the regulator, et-al so I can clean it up? Maybe make it work for a little while longer? I'll be putting the switch back together as I wait for an answer. Heh. Thanks all. D
(Multi-page thread 1 2)
July 13th 06 11:04 PM
by DougW Go to last post
11 1,025
OT - Beirut by Dave Milne[_1_]
The French have turned up in support of Hezbolla with a visit by Prime Minister de Villepin.("support" in the loosest possible sense of the word). I guess that with French support they are now totally doomed ! Dave Milne, Scotland '91 Grand Wagoneer, '99 TJ
(Multi-page thread 1 2)
July 21st 06 01:36 PM
by Stupendous Man Go to last post
11 680
Where is "right fender side shield" by Carl K
Where is "right fender side shield" as described he http://pictures.personnelware.com/gallery2/main.php?g2_view=core.ShowItem&g2_itemId=2029 (important part of http://pictures.personnelware.com/gallery2/main.php?g2_view=core.ShowItem&g2_itemId=2023 which is a 5mb file to get the full size, so...
(Multi-page thread 1 2)
July 21st 06 09:16 PM
by billy ray Go to last post
11 658
Help with oil pressure please. by bushman
2000 6cyl. 45Kmiles The oil pressure drops to 0 and "check gauges" comes on when warm and idling. No other problems. New oil and filter did not help. Thanks - Allen
(Multi-page thread 1 2)
July 29th 06 08:17 PM
by Simon Juncal Go to last post
11 608
Rubicon front locker by Don Hamilton[_1_]
Well I took my out of warranty (55,000 miles) 05 Rubicon to the dealer to get the non locking front locker checked out (just flashes will not engage). The diagnosis of the problem is a bad actuator and wiring connector. The actuator is not covered by the 7/70,000 drive train warranty. Then I was...
(Multi-page thread 1 2)
November 6th 06 02:20 PM
by Thomas Waldron Go to last post
11 674
Post New Thread


Display Options
Showing threads 1861 to 1880 of 8867
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 06:00 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.