A while back my stock fog lights got busted on my '99 Cherokee Sport right before inspection. When it went in, they told me it would be $400 to replace the lights, and when I told them no, they told me they had to take them off for the inspection since they were broken. I have recently found out...

I have an 85 CJ7 that has developed a nasty habit of missing extremely bad at highway speeds or when pulling a utility trailer (when the engine is hot). I have replaced the plugs, coil, dist. cap & rotor, and control module - all of which produced nothing except a much lighter wallet. The fuel...

I was thinking about posting this qustion today in class. So I did so where were you when the planes hit the twin towers? I was in class at Junior high (way before I got my 99 Wrangler) if I remember right it was math. But that day no one was doing math. We were all watching the T.V. when the...

my 88 yj 4.2 is not getting fuel. ive checked the steel fuel line that goes back to the tank. i also have checked every line between this one and the carburetor. none of them are clogged or torn. the fuel filter is new as well as the fuel pump. im about to drop the tank and look at the hoses i...

Friendly Neighborhood Vote Wrangler wrote: > Due to the untimely death of Joseph Bartlo, the incumbent AUK Mascot, > may he rest in peace, it is necessary to call for a special election to > select his replacement to serve the rest of Bartlo's term. Therefore, > I'm calling for nominations. >...

I've got a Koenig winch ???????? don't know what the model or specs are on it. The only numbers I can find on it are; 524 and 49064. I believe this unit would be classified as a PTO winch since it currently driven by a hydraulic motor (oilfield application). I'm wondering if anyone has a book on...

I want to disconnect my sway bars for off road outings. I don't want to buy any after market disconnects right now, just want to disconnect when I need and reconnect when I hit the road. I need suggestions. This is on a 95 YJ. Thanks in advance. Greg

http://jeepgrandcherokeelimited.blogspot.com/2007/10/jeep-snorkle-underwater.html watch this amazing video of a jeep with a snorkle drive under water for several minutes with 3 passengers on board.

my new-to-me 95 yj's rear end is loud as hell and has a bent driver side axle. (im guessing hard wheeling and sand/water crossings are to blame) how much work might it be to swap in a whole rear end from an xj ? i hear they are simler/the same.

Good evening all. My boss has a 1952 Willys Jeep for sale. 4 cyl. Manual. 3 sticks on the floor. Jerry can. I believe Dana 44 front and rear. Newer top. Paint is faded, but the body is pretty good. I am interested in buying it from him. He wants to get $7500 for it. It starts and drives fine. Can...

very informative step by step guide... http://cometo.know.googlepages.com/how_to_obtain_car_insurance

Last week my '96 Grand Laredo 6 cyl. wouldn't start. When i turned the key nothing happened. no starter motor...no chatter of the selinoid, no noise at all except a whrrrr in the back that I assumed was the fuel pump. The battery was charged, the head lights, stereo, etc worked fine but the...

I am towing my 1986 Jeep CJ-7 on a U-Haul tow dolly (front wheels off the ground, rear wheels on the ground) I think I have a T-176 manual tranny. Do I need to disconnect the rear drive-shaft or can I just put the tranny in nuetral and tow it. Any suggestions will be helpful. Thanks

Hi guys, My CJ's AMC 20 makes a click in the left rear out near the wheel whenever I go from forward to reverse or reverse to forward and put a small load on it. I'm assuming it's the two-piece design of the axle shafts and if I swap in new one piecers it'll fix the problem. What are the best...

About a month ago I first experienced some problem with the fuel system on my '93 Cherokee(4.0L, 128K). Usually when it happens I am driving down the road and the fuel seems to just cut out for a second or two, but comes right back. On two occasions now it has cut out and wont start for a couple...

The back lighting on some of the controls has gone dark. I find one screw near the windshield. This nowhere near releases the housing. I really don't want to rip anything loose. Any tips? (pinging Mike S). Ed Dowdy Fithian IL

Hello, I have had a problem come up lately with my 97 TJ. Anytime it has rained fairly hard or it has been very humid and damp my engine has a hard time moving. IT chugs and skips when I hit the gas it makes it worse. Once I get going a little bit or leave it sitting for about 5-10 minutes...

I live in LA currently but will be moving to South Central Montana in the next few weeks. I've got a friend here in LA who has a Jeep J3000 4x4 (not sure what year it is, looks like mid-late 60's but not sure) with a 427 engine in it. It's been sitting in his backyard for years gathering dust and...

Guess you couldn't answer the last one, so read this. +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ The serial bully displays behaviour congruent with many of the diagnostic criteria for Narcissistic Personality Disorder. Characterised by a pervasive pattern of grandiosity and...

I need a good used ring and pinion for a dana 35c with 3.73 ratio. The cross pin on mine came out and tore up everything. My guy had hoped to save me some $$$ by re-using the ring and pinion since it only had one minor chip on one of the pinion teeth. Well, is growls quite bad and when they...