|
|
|
|
1 |
995 |
|
|
how to get rid of carbon? by
Nospam
I think the 93 5.0 has some carbon built up as the compression test numbers
are higher
Is there a way to clean it out without taking the heads off?
|
|
8 |
581 |
|
|
67 raised rear suspension to fit bigger tires? by
Will
HI, I bought some 255/60 rear tires for my 67 coupe, after recieving
completley incorrect advice about tire fitment, and now they stick
outside of the fender where if I lowered the car off the lift the lip
of the fender would cut into the top of the tire. Could I raise the
rear suspension so the...
|
|
8 |
778 |
|
|
Body Part for 98 by
chrismhaney
Any recommendations on where to get body parts for a 98 convertible? I need
the plastic piece that is under the windshield wipers.
Chris
|
|
0 |
410 |
|
|
67 Mustang won't start by
[email protected]
About a month ago my 67 mustang GT just stopped turning over.
The battery is good.
It was in hurricane season so it was humid but i didn't think it could
cause any damage.
When I turn the key it does absolutely nothing.
the headlights come on bright and the radio plays but there is not even
a peep...
|
|
9 |
609 |
|
|
2007 Mustang GT Question by
Mike
I recently traded in my 2005 GT for a 2007 GT Convertible.
The car at light acceleration (not hard throttle) exhibits a shake like "a
dog wagging it's tail". The dealer has confirmed the shake and are working
on correcting.
It doesn't display this under moderate acceleration and as the car has...
|
|
6 |
428 |
|
|
HORSEPOWER by
Steve[_20_]
Let me enlighten some of you engine wizards about horsepower and torque.
When you read magazines and listen to mechanics you start thinking that
torque and horsepower are two different measures of an engines power. Well,
thats not really so,,,torque and horsepower are related,,,once you draw the...
( 1 2)
|
|
16 |
1,015 |
|
|
Proper water level by
goodnigh
What should the water level be in a cold radiator?
My 351C 4V in a '71 Grande radiator's water level
is about six inches below the filler when the engine is cold.
The car has never overheated and typically runs
in the lower 1/3 of the temperature gauge.
mike
|
|
7 |
460 |
|
|
2007 Shelby GT Production / Pricing by
Ðavïd
.. The new Ford Shelby GT is the third model in the modern Shelby
Mustang portfolio, joining the 500-horsepower Ford Shelby GT500 and
Hertz rental special, Shelby GT-H.
.. The 2007 Ford Shelby GT will be priced a starting MSRP of $36,970.
.. The first production-built Shelby GT, CSM No....
|
|
3 |
705 |
|
|
"Shelby GT500 much improved over the original" by
Mike
Shelby GT500 much improved over the original
The 2007 Ford Shelby GT500 is stiff, stiff, stiff, stiff. Therein lies
the charm. If it were not stiff, it would not require muscle.
at http://www.washtimes.com/autoweekend/20061019-090450-4409r.htm
|
December 27th 06 01:15 PM
by chris
|
3 |
533 |
|
|
5.0 into 66 coupe...help get it running? by
gcroix
Hello all. I have finished putting the 5.0 in my coupe. Everything is
hooked up, I have plenty of fuel pressure. Spark is somewhat intermittent.
I thought my distributor was 180 out, but that didn't help. Suggestions?
Gary in GA
|
December 27th 06 08:31 AM
by Ironrod
|
1 |
415 |
|
|
FORD MUSTANG '' SPRINT'' CANADIAN Limited editon-Need info! by
THEFULLBOSS
HI !
I'm asking all of you who could help me ...I own a 1972 MUSTANG Coupe''
SPRINT '' Canadian limited editon and I couldn't find anything on it?
If someone could send me some informations about this particular car I will
really appreciate!
If someone has pics of them, some dealers brochures,...
|
|
5 |
648 |
|
|
O2 Sensor on 98 V6 by
chrismhaney
I need some help removing this little bugger. It's the one on the driver
side header. Can't seem to get half a dozen wrenches to get a good hold on
it.
Is there a special tool or procedure?
Chris
|
|
3 |
501 |
|
|
Back to the Unintended Acceleration... by
GatorMan
http://www.consumeraffairs.com/news04/2005/acceleration.html
August 22, 2005
The victims of sudden acceleration all tell a similar tale. "I got into
my car and turned on the ignition. I put the car in reverse. The car
rocketed backward into a telephone pole."
While the people who survived...
|
|
5 |
815 |
|
|
1966 Mustang by
TO
Is it possible to repair the rust/corrosion problem around the rear window
of this 66 Mustang?
http://photos.imageevent.com/daxop/posts/rust.jpg
I am looking to purchase this car but if this problem can not be repaired I
rather not buy it.
What do you guys think this car is worth:
1966 Mustang
( 1 2)
|
|
13 |
851 |
|
|
Communists in BC vs. Mustang by
BradandBrooks
Hey all... anyone ever hear of a Mustang (fox) failing a gov't safety for
loose seatbacks... in that the back latch has play in it and moves even when
it is supposedly locked?
I've owned Foxes for a long time and I think they come like that from the
factory. Seriously. Thoughts on what to do...
( 1 2)
|
|
12 |
715 |
|
|
|
|
3 |
611 |
|
|
O2 sensers ? by
louis
When should one change out the O2 sensors ?
|
|
4 |
404 |
|
|
2003 V6 Mustang Power Windows! HELP! by
[email protected]
I have a 2003 Ford Mustang, V6, 51K. Just before my warranty expired my
power window motor died on the driver's side. That was a year and a
half ago. Well, recently, it stopped working again. However, I can hear
the motor running and a clicking thump noise from inside the door
panel. When it...
|
|
1 |
532 |
|
|
91 2.3L mustang steering problems by
[email protected]
I have had problems with my steering since it got cold this winter. I
checked the power steering fluid and it's fine. But when I'm driving it
feels like I have no power steering at all, then every once and a while
it will kick in at the worst moment, like around a sharp corner. So I'm
turning the...
|
|
0 |
379 |