A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Search Forums
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Showing results 1 to 20 of 20
Search took 0.41 seconds.
Search: Posts made by: Bill Kearney
Forum: Jeep April 9th 07, 04:29 AM Posted to rec.autos.makers.jeep+willys
Replies: 13
Views: 1,130
Posted By Bill Kearney
03 JGC - "Tire Pressure Sensor Bad/Missing"???

> expect more since this system will be federallly mandated on all vehicle
in
> a year or so

And if it gets folks to keep the tire pressure at the right levels it'll end
up saving upwards of 12% in...
Forum: Jeep April 9th 07, 04:23 AM Posted to rec.autos.makers.jeep+willys
Replies: 9
Views: 549
Posted By Bill Kearney
Any Jeep CERTIFIED tech on the list here? Quick question...

> Yes, I have retrained the sensors and all four were able to reset fine.
> On BUST, the boot up self test, the EVIC was still reading
> "...BAD/MISSING SENSOR" which tells me it is looking for the...
Forum: Jeep February 26th 07, 03:41 AM Posted to rec.autos.makers.jeep+willys
Replies: 12
Views: 718
Posted By Bill Kearney
Found Front TJ Rubicon Rattle

> The above folklore was more commonly rendered as someone being driven
> nuts by a rattle from their megapriced Italian exotic, only to finally
> have it traced down to a tobacco can with a ball...
Forum: VW water cooled February 22nd 07, 02:00 PM Posted to rec.autos.makers.vw.watercooled
Replies: 11
Views: 453
Posted By Bill Kearney
Help me hotwire my Rabbiit

> You might just be causing enough electrical activity
> to make the fuel pump relay draw again through the resistance. I'd
> have a look at the relay plate and see what kind of mess you...
Forum: VW water cooled February 22nd 07, 01:53 PM Posted to rec.autos.makers.vw.watercooled
Replies: 20
Views: 1,245
Posted By Bill Kearney
2001 Jetta vr6 OVER REVVED bad, runs very rough now!

> My son was cruising down the interstate at 65mph. SOMEHOW
> gearshift got knocked into 1st Overgear during a panic situation.
> (Didnt thimk that was possible), red lined it for about 3...
Forum: Jeep February 22nd 07, 01:46 PM Posted to rec.autos.makers.jeep+willys
Replies: 14
Views: 779
Posted By Bill Kearney
Start up after storage

> I plan to change the oil first, and thought about puling the valve
> cover gaskets and pouting a quart down each side when I refill it.
> Should I pull the plugs and put a _small_ amount of oil in...
Forum: Jeep February 17th 07, 05:20 PM Posted to rec.autos.makers.jeep+willys
Replies: 65
Views: 2,916
Posted By Bill Kearney
D-C might become just D and C.

> when they water down their name by using it to sell
> soft-roaders they also water down their heritage.

That's just sentimental bull****. If they stop selling actual off-roader
then there'd be a...
Forum: Jeep January 31st 07, 04:37 AM Posted to rec.autos.makers.jeep+willys
Replies: 8
Views: 416
Posted By Bill Kearney
I smell gas!

> I had the same problem with my '82 when I first bought it. The fill
> pipes were split. Take a look there first.

Yep, had the same thing happen on mine. The hose rots out and weeps...
Forum: Jeep January 29th 07, 02:16 PM Posted to rec.autos.makers.jeep+willys
Replies: 32
Views: 1,470
Posted By Bill Kearney
Snapped off an exhaust bolt

> Yeah, I realized the WD40 is not the best for rust.

Not the best? More like completely useless against rusted bolts. It's
nowhere near as effective a penetrant as Kroil, Liquid Wrench or PB...
Forum: Jeep January 26th 07, 01:42 PM Posted to rec.autos.makers.jeep+willys
Replies: 14
Views: 685
Posted By Bill Kearney
86 XJ motor replacement

The only thing that swaps in easily is the 3.4L V6. Everything else would
require cutting the firewall sheetmetal to make it fit.

Given how cheap XJs are these days you'd be better off just getting...
Forum: Jeep January 9th 07, 12:30 AM Posted to rec.autos.makers.jeep+willys
Replies: 9
Views: 732
Posted By Bill Kearney
Recovered Stolen '98 TJ with Clutch Problems

> so I can slide the key out while the engine is
> running. This allows me to lock the doors and run into the house for
> quick things and then come back out without putting undue wear on the
>...
Forum: VW water cooled January 9th 07, 12:12 AM Posted to rec.autos.makers.vw.watercooled
Replies: 13
Views: 731
Posted By Bill Kearney
Ignition switch? Headlights cutting out.

"Tom's VR6" > wrote in message
...
> In rec.autos.makers.vw.watercooled, Bill Kearney wrote:
>
> >You remove the bolt at the bottom of...
Forum: VW water cooled January 8th 07, 02:25 PM Posted to rec.autos.makers.vw.watercooled
Replies: 13
Views: 731
Posted By Bill Kearney
Ignition switch? Headlights cutting out.

> It's a 98 Jetta GLX. How hard is it to change the ignition switch? I'm
> worried it might be hard to access due to anti-theft considerations.

The switch is separate from the lock cylinder. You...
Forum: VW water cooled January 8th 07, 02:21 PM Posted to rec.autos.makers.vw.watercooled
Replies: 11
Views: 1,028
Posted By Bill Kearney
ignition switch '96 Jetta

> Geez and I though being able to do it all in less than 1 hour was easy.
;-)
> How long does it take your way drilling out the secure screw and all?

I didn't take out the lock CYLINDER. I took out...
Forum: VW water cooled January 7th 07, 09:56 PM Posted to rec.autos.makers.vw.watercooled
Replies: 12
Views: 3,673
Posted By Bill Kearney
VW GTI VR6 GEar PROBLEM-will not go into 1st and 2nd gear

> The car is in the shop right now but can't afford the dealers quote of
> either replacing the two forks for the first or second gear that he is
> saying that needs to be replaced or replace the...
Forum: VW water cooled January 7th 07, 09:44 PM Posted to rec.autos.makers.vw.watercooled
Replies: 11
Views: 1,028
Posted By Bill Kearney
ignition switch '96 Jetta

There's a MUCH easier way.

Center the wheel
Pull the fascia panels (top/bottom of column and lower panel).
Pull the wiring to everything on the column. It's about 8 connectors.
Center the wheel ...
Forum: VW water cooled January 7th 07, 09:43 PM Posted to rec.autos.makers.vw.watercooled
Replies: 11
Views: 1,028
Posted By Bill Kearney
ignition switch '96 Jetta

> Ok, so i got the part where i need a puller to remove the column. Here's
my
> problem, the reason why i am removing my ignition switch is because i
> rewired another switch that i installed in the...
Forum: VW water cooled January 7th 07, 02:40 AM Posted to rec.autos.makers.vw.watercooled
Replies: 5
Views: 330
Posted By Bill Kearney
intermittant starting in 96 cabrio?

It was the switch. There are two ways to replace it. One is to pull the
steering wheel, airbag and the lock bracket. The other is to pull the whole
column. Do the latter. Loosen the nut at the...
Forum: Jeep December 28th 06, 05:29 PM Posted to rec.autos.makers.jeep+willys
Replies: 5
Views: 550
Posted By Bill Kearney
swaping engines

> Check the Advance Adapters web site. http://advanceadapters.com Pay
> particular attention to their Jeep Conversion Manual, which used to sell
for
> $10, well worth it. The V8 will fit if you...
Forum: Jeep December 20th 06, 04:25 PM Posted to rec.autos.makers.jeep+willys
Replies: 36
Views: 2,572
Posted By Bill Kearney
Darn Tire Pressure sensors

> I have an '04 Liberty Limited Edition and the only complaint that I have
are
> with those @#!%$# radio transmittors in the valve stems (Tire Pressure
> Monitoring Display) which are too sensitive...
Showing results 1 to 20 of 20

 
Forum Jump

All times are GMT +1. The time now is 08:26 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.