The replacement input shaft seal does not have a metal outer edge.
Is it supposed to have one?
If so, where can I get one?
TIA
-----------------------------------

On Aug 5, 12:18 pm, "P.J.Berg" > wrote:
> On Tue, 05 Aug 2008 17:45:24 +0200, > wrote:
> > Hello!
> > What kind of home made sleeve tool can I make that does not require
> > welding to install the tranny input shaft seal?
>
> > I was thinking of a flat washer just a little smaller diameter as the
> > input shaft seal and a short piece of pvc pipe and a rubber mallet.
>
> > Thanks In Advance!
> > Any help will be appreciated!
>
> You can do it with a flat nosed punch/drift, make sure it has no sharp
> edges.
> Also make sure you get the seal square when you start, slowly round round
> and in it goes.
> Or if you have a large diameter pipe, type water or gas, preferably the
> same O.d as the seal you can tap it in with this using a heavy big hammer
> or short-shaft sledgehammer.
>
> J.
>
> --
> Using Opera's revolutionary e-mail client:http://www.opera.com/mail/