Any tips / experience regarding removal of the master cylinder on a 1950
Chevy Fleetline Deluxe??
I am stumped!
Does the pivoting part on the master cylinder slide out after removing
spring and bolt through the plunger, or does the whole arm up to the brake
pedal have to be removed with it??? I CANNOT see how to unbolt up there if
so. Just can't reach it... under, over, sideways,... does one have to
remove engine and or body from frame just to remove the master cylinder???
Or does one need to cut out the floor board??? I am quite frustrated with
it at this point to put it mildly!