View Single Post
  #7  
Old October 19th 06, 11:59 AM posted to rec.autos.makers.chrysler
Fiberman
external usenet poster
 
Posts: 5
Default 300m water noise

just as you said, thank you so much
"Bill Putney" > wrote in message
...
> Bill Putney wrote:
>> Fiberman wrote:
>>
>>> coming from under the dash on acceleration, any ideas?

>>
>>
>> You need to bleed the system of air. Make sure coolant pressure bottle
>> is filled to the MAX line (don't remove cap on warm or hot engine), start
>> it up, let it warm up to pressurize the system, turn it off. Open
>> bleeder (on top front of engine - looks exactly like a brake bleeder).
>> Air should come out at first. When you see a steady stream of water come
>> out, close the bleeder. Check level in pressure bottle and top it off
>> again, if needed, after it cools down.
>>
>> Bill Putney
>> (To reply by e-mail, replace the last letter of the alphabet in my
>> address with the letter 'x')

>
> Hopefully there's not a problem that is putting air into the system (bad
> gasket, water pump leaking causing low coolant and air in system, etc.)
> and a one time bleeding will take care of it. If it continues to happen,
> then that will have to be investigated, but you need to do the initial
> bleeding to see where you are (i.e., to see if it recurs and/or look for
> leak).
>
> Bill Putney
> (To reply by e-mail, replace the last letter of the alphabet in my address
> with the letter 'x')



Ads