If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Drop Pitman arm or Tie-rod flip kit?
I'll be going SOA on my 89 YJ next weekend. I've heard it both ways for
either getting a 4" drop pitman arm or doing a tie rod flip kit. I'm partial to the tie rod flip kit as it helps to protect the tie rods. What's the verdict on both? Carl |
Ads |
#2
|
|||
|
|||
"Carl Saiyed" > wrote in message ... > I'll be going SOA on my 89 YJ next weekend. I've heard it both ways for > either getting a 4" drop pitman arm or doing a tie rod flip kit. I'm > partial > to the tie rod flip kit as it helps to protect the tie rods. What's the > verdict on both? Flip the tie rod. Better yet, use this as the excuse you needed to buy a hi-steer setup. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Alfa flip key - opening & key blade removal | PhilipS | Alfa Romeo | 5 | March 5th 05 07:22 PM |
`96 Grand Cherokee Pitman Arm | unix-freak | Jeep | 3 | February 18th 05 06:57 PM |
Is a 2" inch drop too much | BeverlyOmasta | Ford Mustang | 3 | February 1st 05 12:27 AM |
Lightweight 4x4, flip down windshield | Jack Daynes | 4x4 | 64 | May 20th 04 05:44 AM |