If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Engine oil cooler line replacement?
Hello folks,
I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler in it and the supply line that connects the cooler (upper radiator) to the control valve is leaking. Is this a hard thing to replace myself? Would it be wise for me to use an old line off of a used car? The new line is very expensive from Chrysler dealers! Any other comments or pointers on this is greatly appreciated Thank you. |
Ads |
#2
|
|||
|
|||
Engine oil cooler line replacement?
Possibly the transmission fluid (not engine oil) cooler line? I've not
replaced one on your model/year, but did so on an older LH body since it too was leaking. I bought the part at the dealer and the part was about $50. Installation was not too difficult. I figured any old part would likely be prone to the same issue. In addition, $50 just wasn't worth the effort of pulling it at a salvage yard. Bob "Lisa" > wrote in message ... > Hello folks, > > I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler > in it and the supply line that connects the cooler (upper radiator) to the > control valve is leaking. Is this a hard thing to replace myself? Would it > be wise for me to use an old line off of a used car? The new line is very > expensive from Chrysler dealers! > > Any other comments or pointers on this is greatly appreciated Thank you. > > |
#3
|
|||
|
|||
Engine oil cooler line replacement?
I think Bob may be right about it being the transmission cooler line. They have screw clamps on those lines - usually it's a matter of tightening the clamps back up rather than a hole in the line. (I own two 2nd gen. Concordes.) That would cost $zero. Bill Putney (To reply by e-mail, replace the last letter of the alphabet in my address with the letter 'x') Bob Shuman wrote: > Possibly the transmission fluid (not engine oil) cooler line? I've not > replaced one on your model/year, but did so on an older LH body since it too > was leaking. I bought the part at the dealer and the part was about $50. > Installation was not too difficult. I figured any old part would likely be > prone to the same issue. In addition, $50 just wasn't worth the effort of > pulling it at a salvage yard. > > Bob > > > > "Lisa" > wrote in message > ... >> Hello folks, >> >> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler >> in it and the supply line that connects the cooler (upper radiator) to the >> control valve is leaking. Is this a hard thing to replace myself? Would it >> be wise for me to use an old line off of a used car? The new line is very >> expensive from Chrysler dealers! >> >> Any other comments or pointers on this is greatly appreciated Thank you. |
#4
|
|||
|
|||
Engine oil cooler line replacement?
Thanks Bob.
It is actually engine oil cooler lines. The transmission cooler lines or on the other side (left side of the radiator), the engine cooler line or on the right side of the radiator. I was at the dealer yesterday and they said it was engine oil and I said the same thing you said but they explained that some of these Concorde models came with an optional engine oil cooler. BTW, the wanted $480 to replace the 2 lines, I can't tell you what I said but you'd probably figure that out yourself. Thanks again. "Bob Shuman" > wrote in message ... > Possibly the transmission fluid (not engine oil) cooler line? I've not > replaced one on your model/year, but did so on an older LH body since it > too was leaking. I bought the part at the dealer and the part was about > $50. Installation was not too difficult. I figured any old part would > likely be prone to the same issue. In addition, $50 just wasn't worth > the effort of pulling it at a salvage yard. > > Bob > > > > "Lisa" > wrote in message > ... >> Hello folks, >> >> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler >> in it and the supply line that connects the cooler (upper radiator) to >> the control valve is leaking. Is this a hard thing to replace myself? >> Would it be wise for me to use an old line off of a used car? The new >> line is very expensive from Chrysler dealers! >> >> Any other comments or pointers on this is greatly appreciated Thank you. >> >> > > |
#5
|
|||
|
|||
Engine oil cooler line replacement?
Bill, thank you too.
As I explained to Bob, I have the optional engine oil cooler in my car and these are engine oil lines. "Bill Putney" > wrote in message ... > > I think Bob may be right about it being the transmission cooler line. They > have screw clamps on those lines - usually it's a matter of tightening the > clamps back up rather than a hole in the line. (I own two 2nd gen. > Concordes.) > > That would cost $zero. > > Bill Putney > (To reply by e-mail, replace the last letter of the alphabet in my address > with the letter 'x') > > > Bob Shuman wrote: >> Possibly the transmission fluid (not engine oil) cooler line? I've not >> replaced one on your model/year, but did so on an older LH body since it >> too was leaking. I bought the part at the dealer and the part was about >> $50. Installation was not too difficult. I figured any old part would >> likely be prone to the same issue. In addition, $50 just wasn't worth >> the effort of pulling it at a salvage yard. >> >> Bob >> >> >> >> "Lisa" > wrote in message >> ... >>> Hello folks, >>> >>> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler >>> in it and the supply line that connects the cooler (upper radiator) to >>> the control valve is leaking. Is this a hard thing to replace myself? >>> Would it be wise for me to use an old line off of a used car? The new >>> line is very expensive from Chrysler dealers! >>> >>> Any other comments or pointers on this is greatly appreciated Thank you. |
#6
|
|||
|
|||
Engine oil cooler line replacement?
"Lisa" > wrote in message ... > Hello folks, > > I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler in > it and the supply line that connects the cooler (upper radiator) to the > control valve is leaking. Is this a hard thing to replace myself? Would it > be wise for me to use an old line off of a used car? The new line is very > expensive from Chrysler dealers! > > Any other comments or pointers on this is greatly appreciated Thank you. > > Where and how is it leaking? If this is a steel tube (which it really should be) and there is a crack or some such in the tubing itself, then take the tube off and take it to a radiator shop and have them braise the crack or hole. Ted |
#7
|
|||
|
|||
Engine oil cooler line replacement?
"Lisa" > wrote in message ... > Bill, thank you too. > > As I explained to Bob, I have the optional engine oil cooler in my car and > these are engine oil lines. > > "Bill Putney" > wrote in message > ... > > > > I think Bob may be right about it being the transmission cooler line. They > > have screw clamps on those lines - usually it's a matter of tightening the > > clamps back up rather than a hole in the line. (I own two 2nd gen. > > Concordes.) > > > > That would cost $zero. > > > > Bill Putney > > (To reply by e-mail, replace the last letter of the alphabet in my address > > with the letter 'x') > > > > > > Bob Shuman wrote: > >> Possibly the transmission fluid (not engine oil) cooler line? I've not > >> replaced one on your model/year, but did so on an older LH body since it > >> too was leaking. I bought the part at the dealer and the part was about > >> $50. Installation was not too difficult. I figured any old part would > >> likely be prone to the same issue. In addition, $50 just wasn't worth > >> the effort of pulling it at a salvage yard. > >> > >> Bob > >> > >> > >> > >> "Lisa" > wrote in message > >> ... > >>> Hello folks, > >>> > >>> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler > >>> in it and the supply line that connects the cooler (upper radiator) to > >>> the control valve is leaking. Is this a hard thing to replace myself? > >>> Would it be wise for me to use an old line off of a used car? The new > >>> line is very expensive from Chrysler dealers! > >>> > >>> Any other comments or pointers on this is greatly appreciated Thank you. > The lines you are referring to have to be replaced if they are leaking, They can not be fixed. When they leak, it is normally severe. I wouldn't pay more the 2.0hrs to have them installed Glenn Beasley Chrysler Tech |
#8
|
|||
|
|||
Engine oil cooler line replacement?
Max,
I ordered the line yesterday, I am going to give it a shot myself..I think it is a straight forward replacement. Thanks. "maxpower" > wrote in message . .. > > "Lisa" > wrote in message > ... >> Bill, thank you too. >> >> As I explained to Bob, I have the optional engine oil cooler in my car >> and >> these are engine oil lines. >> >> "Bill Putney" > wrote in message >> ... >> > >> > I think Bob may be right about it being the transmission cooler line. > They >> > have screw clamps on those lines - usually it's a matter of tightening > the >> > clamps back up rather than a hole in the line. (I own two 2nd gen. >> > Concordes.) >> > >> > That would cost $zero. >> > >> > Bill Putney >> > (To reply by e-mail, replace the last letter of the alphabet in my > address >> > with the letter 'x') >> > >> > >> > Bob Shuman wrote: >> >> Possibly the transmission fluid (not engine oil) cooler line? I've >> >> not >> >> replaced one on your model/year, but did so on an older LH body since > it >> >> too was leaking. I bought the part at the dealer and the part was > about >> >> $50. Installation was not too difficult. I figured any old part would >> >> likely be prone to the same issue. In addition, $50 just wasn't >> >> worth >> >> the effort of pulling it at a salvage yard. >> >> >> >> Bob >> >> >> >> >> >> >> >> "Lisa" > wrote in message >> >> ... >> >>> Hello folks, >> >>> >> >>> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil > cooler >> >>> in it and the supply line that connects the cooler (upper radiator) >> >>> to >> >>> the control valve is leaking. Is this a hard thing to replace myself? >> >>> Would it be wise for me to use an old line off of a used car? The new >> >>> line is very expensive from Chrysler dealers! >> >>> >> >>> Any other comments or pointers on this is greatly appreciated Thank > you. >> > > The lines you are referring to have to be replaced if they are leaking, > They > can not be fixed. When they leak, it is normally severe. I wouldn't pay > more > the 2.0hrs to have them installed > > Glenn Beasley > Chrysler Tech > > |
#9
|
|||
|
|||
Engine oil cooler line replacement?
Ted,
This line is part steel, part rubber and it is leaking right at the joint between the steel and rubber part, I don't think it could be fixed. It has to be replaced as Maxpower suggested. Thanks. "Ted Mittelstaedt" > wrote in message ... > > "Lisa" > wrote in message > ... >> Hello folks, >> >> I got a 2001 Concorde with the 3.2 engine. It's got an engine oil cooler > in >> it and the supply line that connects the cooler (upper radiator) to the >> control valve is leaking. Is this a hard thing to replace myself? Would >> it >> be wise for me to use an old line off of a used car? The new line is very >> expensive from Chrysler dealers! >> >> Any other comments or pointers on this is greatly appreciated Thank you. >> >> > > Where and how is it leaking? If this is a steel tube (which it really > should be) > and there is a crack or some such in the tubing itself, then take the tube > off > and take it to a radiator shop and have them braise the crack or hole. > > Ted > > |
#10
|
|||
|
|||
Engine oil cooler line replacement?
> The lines you are referring to have to be replaced if they are leaking, They > can not be fixed. When they leak, it is normally severe. I wouldn't pay more > the 2.0hrs to have them installed > > Glenn Beasley > Chrysler Tech Glen Do these lines appear on any other 2001 Chrysler vehicles? Like maybe my 2001 LHS? Thanks Bob AZ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
91 Cherokee Automatic Trans cooler line repair/replacement? (Nothing to say of any relevance, just C&P Crap) | L.W. \(Bill\) Hughes III[_189_] | Auto Photos | 0 | July 4th 07 03:17 AM |
91 Cherokee Automatic Trans cooler line repair/replacement? (Nothing to say of any relevance, just C&P Crap) | L.W. \(Bill\) Hughes III[_188_] | Auto Photos | 0 | July 4th 07 03:17 AM |
91 Cherokee Automatic Trans cooler line repair/replacement? | clay | Jeep | 18 | July 4th 07 03:01 AM |
Engine Replacement - How to line up transmission to engine | Steve | Dodge | 1 | July 13th 05 06:22 AM |