If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
95 LHS
My girls car is trippin and the check engine light came on so I did
diagnostic code check and the code I came up with is 12 which is the start of codes and the 54 which I dont know what it is, then 55 which is the end of the codes.. My question is What code is 54?? everytime the CEL comes on the car cuts-off!!!!!! |
Ads |
#2
|
|||
|
|||
95 LHS
Rome97neon wrote: > My girls car is trippin and the check engine light came on so I did > diagnostic code check and the code I came up with is 12 which is the start of > codes and the 54 which I dont know what it is, then 55 which is the end of > the codes.. My question is What code is 54?? everytime the CEL comes on the > car cuts-off!!!!!! No camshaft signal during engine cranking. Ken |
#3
|
|||
|
|||
95 LHS
Ken Weitzel wrote:
>> My girls car is trippin and the check engine light came on so I did >> diagnostic code check and the code I came up with is 12 which is the start of >> codes and the 54 which I dont know what it is, then 55 which is the end of >> the codes.. My question is What code is 54?? everytime the CEL comes on the >> car cuts-off!!!!!! > >No camshaft signal during engine cranking. > >Ken Ok so what do I need todo to fix that? Change the cam sensor or is that the PCM that causes that?? -- Message posted via http://www.carkb.com |
#4
|
|||
|
|||
95 LHS
Ken Weitzel wrote:
>> My girls car is trippin and the check engine light came on so I did >> diagnostic code check and the code I came up with is 12 which is the start of >> codes and the 54 which I dont know what it is, then 55 which is the end of >> the codes.. My question is What code is 54?? everytime the CEL comes on the >> car cuts-off!!!!!! > >No camshaft signal during engine cranking. > >Ken Ok so what do I need todo to fix that? Change the cam sensor or is that the PCM that causes that?? -- Message posted via http://www.carkb.com |
#5
|
|||
|
|||
95 LHS
Rome97neon via CarKB.com wrote: > Ken Weitzel wrote: > >>>My girls car is trippin and the check engine light came on so I did >>>diagnostic code check and the code I came up with is 12 which is the start of >>>codes and the 54 which I dont know what it is, then 55 which is the end of >>>the codes.. My question is What code is 54?? everytime the CEL comes on the >>>car cuts-off!!!!!! >> >>No camshaft signal during engine cranking. >> >>Ken > > > Ok so what do I need todo to fix that? Change the cam sensor or is that the > PCM that causes that?? Hi... Ooops, not a mechanic, just told you what the code was. Hopefully the mechanics here will tell you what to do next However, if you want to, I think it's safe for you to make sure the connection is good... perhaps unplug it and plug it in again a time or two. Don't remove it from the engine. If she has the 3.5 engine you can find it real easy. Standing in front of the car, look at the thermostat housing. About 3 or 4 inches to the right of that there's a device that "sticks into" the (driver's side) cam housing. Take care. Ken |
Thread Tools | |
Display Modes | |
|
|