If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
propane hot enough for broken bolt removal?
long story short, a small (1/4" 5/16" diameter?) thermostat housing
bolt broke. about 3/8" of it is sticking out of the aluminum engine block, with the cap missing. i want to heat it up, but only have access to a cheap propane torch. will this do any good? i was thinking that heating, then one of the craftsman socket-like removal tools. thoughts? there isnt any chance of damaging/warping anything with a measly propane torch, right? thanks, anthony |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1998 Honda Accord 4-cyl Allen Head Bolt Under Oil Filter - what is it? | amp11plzDontSpam | Honda | 0 | January 17th 05 09:26 AM |
having difficulty removing engine mount bolt | Bil | Honda | 0 | October 25th 04 02:04 AM |
Bolt Removal Problems | Caroline | Honda | 3 | September 24th 04 01:05 PM |