If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
are fuses always on 12V side of a device?
I find a lot of vehicles used "switched earth" system, where devices join
to a 12 V main wire, and are switched on the earth side. But then, would the fuse still be on the hot side for extra safety? So I believe it should look like this: 12V--fuse--lamp--switch--earth |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Save Gas with your GPS Device | virig[_2_] | Mazda | 2 | August 28th 08 01:14 AM |
I think I have a cloaking device.... | Brent P[_1_] | Driving | 2 | October 22nd 07 06:23 AM |
Inforad device (UK) | Nick | BMW | 0 | June 2nd 06 11:58 PM |
Diagnostic device | [email protected] | Ford Mustang | 2 | February 28th 06 12:01 AM |
Here is a cool GPS device | Tom | 4x4 | 0 | July 21st 04 12:46 PM |