If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Front torsion bar removal
Not sure it is a good idea removing an entire front torsion bar. I have a
beck spyder and removed the four "smaller bars" from the upper torsion housing because of the weight of the spyder. I did find that I had to use the adjustment nuts to reset the height i wanted. I also would be interested in hearing what others have to say...... Joe |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
front end removal | YT | Corvette | 0 | March 31st 05 07:34 PM |
Running in low range 4wd with front hubs unlocked | Neil Klaer | 4x4 | 3 | September 20th 04 11:45 PM |
CJ8 front springs & stabilizer bar removal | Michael Pomeroy | 4x4 | 1 | July 5th 04 05:01 PM |
Hum/Vibration in front of of '95 Explorer | Mr. Knowitall | 4x4 | 0 | December 17th 03 11:28 PM |