|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 29th 04, 02:49 AM
|
|||
|
|||
16v 2.0 oil pump
I replaced the cylinder head on my 91 Passat 16V 2.0 . It starts and runs
but there is NO oil pressure. Won't even fill the filter can. What did I screw up? Thanks Dave 
|
| Ads |
|
#2
September 30th 04, 12:42 PM
|
|||
|
|||
|
Why did it need the head?
"ken" > wrote in message ... >I replaced the cylinder head on my 91 Passat 16V 2.0 . It starts and runs > but there is NO oil pressure. Won't even fill the filter can. What did I > screw up? Thanks Dave > >
|
|
#3
October 1st 04, 01:33 PM
|
|||
|
|||
|
Head gasket leak. Overheated. Warped head. Oil pressure had not been an
issue until I took this thing apart and back together. There is NO oil flowing at all. Filter can is dry. "Woodchuck" > wrote in message ... Why did it need the head? "ken" > wrote in message ... >I replaced the cylinder head on my 91 Passat 16V 2.0 . It starts and runs > but there is NO oil pressure. Won't even fill the filter can. What did I > screw up? Thanks Dave > >
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Screenwash pump anomoly?? | Mr Fix It | BMW | 0 | December 21st 04 10:56 PM |
| C3 smog pump problem | B Dragon | Corvette | 40 | December 13th 04 10:08 PM |
| Fuel Pump Bad Again ?! | Paul Brogren | Jeep | 2 | December 5th 04 05:51 PM |
Linear Mode
