If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Installing an MSD-6A in a 1972 Mustang
I'm installing an MSD-6A in a 1972 Ford Mustang, 351C-4V, manual
4-speed toploader. I need to connect the small red wire from the 6A to a +12V switched source (needs to be +12V at the run and start conditions of the ignition switch). Any recommendations as to where to tap in for this source? On the starter relay, there one of the small posts is +12V in the run, but I don't know if it is +12V in the start position. Thanks... |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mustang Kicks GTO Butt | [email protected] | Ford Mustang | 14 | April 21st 05 01:34 AM |
2007 Shelby GT500 Mustang | Dan | Ford Mustang | 30 | March 25th 05 12:35 AM |
FORD TO INCREASE MUSTANG PRODUCTION TO MEET RUNAWAY CONSUMER DEMAND | Grover C. McCoury III | Ford Mustang | 1 | March 23rd 05 11:08 PM |
Mustang Returns to Sports Car Racing | Grover C. McCoury III | Ford Mustang | 0 | January 29th 05 05:39 PM |
21st Century Goat vs Mustang Shootout | [email protected] | Ford Mustang | 1 | January 15th 05 06:09 PM |