If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Renix E.F.I. tip
One difficulty Jeep owners have with the Renix Fuel Injection is setting the
TPS correctly. I found myself needing to set my son's 88 XJ's TPS without a vehicle battery. The method I used was to take the throttle body off the engine and suppling voltage from a couple "D" cells, then set the output voltage to 17 % of the battery voltage checking the pins as described in my Chiltons or Haynes manual with a DVOM. Then I re-installed the throttle body on the engine.This was two weeks ago, btw. We put a battery in the XJ yesterday and cranked her up. Idle quickly settled in to a sweet 700 rpm initially and after the computer finished it's initial learn cycle it dropped to 650 rpm. I have found setting the percentage of the output voltage to be far more accurate and easier than using the recommended voltage in the manual. And being able to adjust it off engine makes it even better. -- Budd |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Handy tip for Renix injection systems TPS adjustment. | Budd Cochran[_2_] | Jeep | 2 | February 25th 12 07:07 PM |
Renix flywheel question? | [email protected] | Jeep | 7 | June 23rd 05 05:56 AM |