If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
front bumper emoval Audi 80 '90
Hi
I've just got an Audi 80 '90, and haven't been able to get a manual yet. Now I have to remove the front bumper. I can't find the mounting bolts! Where are they located? Is there anything I have to remve before I can remove the bumper? /Sven |
Ads |
#2
|
|||
|
|||
If it is like most others of the breed you will find two Allen bolts that are
mounted up from the bottom of the bumper on either side of the license plate. Remove these and the bumper will slide forward and off. Be careful to disconnect the lights in the bumper and any ducting to the radiator or oil cooler if so equipped. Easy to do but really need two people to avoid damaging parts. Sven Agardh wrote: > Hi > > I've just got an Audi 80 '90, and haven't been able to get a manual yet. > Now I have to remove the front bumper. I can't find the mounting bolts! > Where are they located? Is there anything I have to remve before I can > remove the bumper? > > /Sven |
#3
|
|||
|
|||
Thanks for the tips, but I can't find any bolts on the bottom of the
bumper. Is my bolt searching ability too low or is my car not like most others? /Sven Tony wrote: > If it is like most others of the breed you will find two Allen bolts > that are mounted up from the bottom of the bumper on either side of the > license plate. Remove these and the bumper will slide forward and off. > > Be careful to disconnect the lights in the bumper and any ducting to the > radiator or oil cooler if so equipped. > > Easy to do but really need two people to avoid damaging parts. > > Sven Agardh wrote: > >> Hi >> >> I've just got an Audi 80 '90, and haven't been able to get a manual >> yet. Now I have to remove the front bumper. I can't find the mounting >> bolts! Where are they located? Is there anything I have to remve >> before I can remove the bumper? >> >> /Sven |
#4
|
|||
|
|||
Again, if it is like others, There are two holes on the bottom of the curve of
the bumper (not on the very bottom) molded into the painted portion. They may have plastic covers over them. Up inside the holes about a half inch are the bolts. The bolts are though the front of the shock absorbers which absorb low speed front end collision that the bumper is mounted on. Sven Agardh wrote: > Thanks for the tips, but I can't find any bolts on the bottom of the > bumper. Is my bolt searching ability too low or is my car not like most > others? > > /Sven > > Tony wrote: > >> If it is like most others of the breed you will find two Allen bolts >> that are mounted up from the bottom of the bumper on either side of >> the license plate. Remove these and the bumper will slide forward and >> off. >> >> Be careful to disconnect the lights in the bumper and any ducting to >> the radiator or oil cooler if so equipped. >> >> Easy to do but really need two people to avoid damaging parts. >> >> Sven Agardh wrote: >> >>> Hi >>> >>> I've just got an Audi 80 '90, and haven't been able to get a manual >>> yet. Now I have to remove the front bumper. I can't find the mounting >>> bolts! Where are they located? Is there anything I have to remve >>> before I can remove the bumper? >>> >>> /Sven |
#5
|
|||
|
|||
If it's like an '88, you have to remove the strip of metal that runs
all the way around between the bumper and grille. Under there, you should see the bolts you need to get to. The trim strip just pops off, but be gentle or you'll bend it. On Sat, 28 May 2005 11:55:51 +0200, Sven Agardh > wrote: >Hi > >I've just got an Audi 80 '90, and haven't been able to get a manual yet. >Now I have to remove the front bumper. I can't find the mounting bolts! >Where are they located? Is there anything I have to remve before I can >remove the bumper? > >/Sven |
#6
|
|||
|
|||
front bumper emoval Audi 80 '90
Hi guys, there is two 6mm allen bolts you will have to remove to slite the bumper off. Be sure that u are two to remove the bumper to not destroy other parts. Here's a picture. http://imgur.com/2VYazMY
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
E39 front bumper - question .. HELP | piotrmonter | BMW | 1 | July 14th 05 04:58 AM |
Front brakes dragging, no rear pressure, all disc | [email protected] | Technology | 6 | April 25th 05 08:04 PM |
General front end alignment question | James | Technology | 7 | April 9th 05 03:46 AM |
How to reset service reminder? | Stan Dowiat | BMW | 12 | March 16th 05 05:31 PM |
Q:Right-Lock lockers | Zenteren | 4x4 | 16 | January 16th 04 08:57 AM |