If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
stall problem, Head gasket?
I have an 87 reliant 2.5 with a stall problem.I checked all vaccum
lines,changed map sensor,fuel filter and fuel regulator. Also replaced cap,rotor, and new wires,themostat and antifreeze. Could the head gasket need tourqing ? The car starts ok cold and runs for 5 mins. then stalls. I wait 5mins. it starts and runs good.I would appreciate any info. Also car seems to have good comprresion. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 6 | December 7th 06 04:55 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 2 | April 22nd 05 05:32 AM |
Might be a blown head gasket, might not... How to tell? | Don Bruder | Technology | 10 | February 4th 05 02:54 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 4 | February 2nd 05 05:22 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | November 1st 04 05:24 AM |