If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Separation of door panels above armrest on early 1990's 5 series
Trevor, I have a 92 325i with the same problem!
a friend of mine with a 328 suggested I use a hypo filled with super glue and inject it where needed. I guess you would have to hold each section down until the glue adheres and go in little steps. I guess the worst that happens is that we f--- it up and have to go for a different fix or a new panel! Good luck! If you hear of any other ideas, let me know ok? |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fixing the ubiquitous BMW armrest tray design flaw | Shaft Drive | BMW | 5 | October 6th 05 07:09 PM |
Fixing the ubiquitous BMW armrest tray design flaw | Shaft Drive | Technology | 6 | October 6th 05 07:09 PM |
Armrest - early Voyager/Caravan | BeeP | Chrysler | 0 | October 10th 04 04:51 AM |