If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Transmission pan bolt torque 01 Jetta Automatic
Hi,
I know I've stripped one hole on the tranny housing that holds the 4 bolts for the transmision pan. Looks like I can drill through to the other side, use a longer bolt and nut. Does anyone know the torque required to tighten these 4 bolts? I have a Bentley and a Haynes and neither says. I'd rather not do this again. Thanks for any help, Dermott |
Ads |
#2
|
|||
|
|||
Transmission pan bolt torque 01 Jetta Automatic
Helicoil repair that hole
http://www.roadstarmagazine.com/modu...rticle&sid=233 Sometimes the original metal will weaken with age and may not hold the proper torque specs. :-( > wrote in message oups.com... > Hi, > I know I've stripped one hole on the tranny housing that holds the 4 > bolts for the transmision pan. Looks like I can drill through to the > other side, use a longer bolt and nut. > > Does anyone know the torque required to tighten these 4 bolts? I have > a Bentley and a Haynes and neither says. I'd rather not do this > again. > > Thanks for any help, > > Dermott > |
#3
|
|||
|
|||
Transmission pan bolt torque 01 Jetta Automatic
Thank you,
I know I went way over 6 ft-lbs! Thanks again, Dermott |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1995 A3 Jetta - Automatic Transmission Problems | tombstone | VW water cooled | 15 | January 17th 07 04:10 AM |
1994 Jetta GL 2.0L Automatic transmission | pdmalo | VW water cooled | 4 | October 1st 06 08:39 AM |
Chrysler T&C caliper bolt torque | ECLiPSE 2002 | Technology | 0 | July 28th 06 08:51 PM |
Cylinder head Bolt Torque | Brian | Chrysler | 3 | August 30th 05 11:52 PM |
Audi A4 wheel bolt torque | sjsturner | Audi | 2 | August 28th 04 02:42 AM |