|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 3rd 07, 09:06 AM
posted to rec.autos.makers.mazda.miata
|
|||
|
|||
cyl head removal and oil pan removal.
I am considering doing a removal and rebuild of the top end. But I was
also considering a re-ring . I would do so if I could easily remove and replace the oil pan and other stuff to push out the pistons for a cleaning and a fresh set of rings. Can this be done easily with the engine block remaining in the car? In other words, can the oil pan be removed and replaced easily? BTW it is a 1996 Miata.... But I assume it would be similar to all years? 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
