|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 12th 08, 03:01 PM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
wheel bearing costs
has anyone found a good cheap wheel bearing for the front axles on the
xj's 
|
| Ads |
|
#2
April 12th 08, 03:24 PM
posted to rec.autos.makers.jeep+willys
|
|||
|
|||
|
wheel bearing costs
mr.som ting wong wrote:
> has anyone found a good cheap wheel bearing for the front axles on the > xj's > You get what you pay for. At $350.00 labour per side to change inner front axle bearings, 'I' would pay for the 'best' ones I could find, same for the seals. As far as the hub bearings go, same deal. They are sealed units that only come with a hub. The 'machine shop' labour to replace these would run more than even expensive bearings cost. If cheap hub bearings fail, your front wheel simply falls off. No thanks, it isn't fun at all to have a front wheel fall off at 60 mph.... Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 'New' frame in the works for '08. Some Canadian Bush Trip and Build Photos: http://mikeromainjeeptrips.shutterfly.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Wheel Bearing | Scott Hughes | Mazda | 4 | June 7th 06 01:01 AM |
| Bearing Races Question and Wheel Bearing Pack Question | Kevin Holzer | VW air cooled | 3 | June 11th 05 05:51 AM |
| Costs for repairing a spun bearing, rebuild or shortblock? | Corky Scott | Technology | 8 | April 14th 05 03:48 AM |
| Costs for repairing a spun bearing, rebuild or shortblock? | Daniel J. Stern | Chrysler | 5 | April 14th 05 03:48 AM |
| WHEEL BEARING | FOR1196D | 4x4 | 8 | April 3rd 04 03:37 PM |
Linear Mode
