If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
5.9 Hi-Po Intake Manifold
Fred V. did pass the time by typing:
>> http://www.billhughes.com/temp/mopar59AMC360.jpg AMC has distributor at >> front. > > Where it should be! no no no... the distributor should be crammed up against the firewall to provide as small a space as possible to get a wrench on the hold down bolt while all the time having to move parts and bits back and forth over an open carb. :] -- DougW |
Ads |
#12
|
|||
|
|||
5.9 Hi-Po Intake Manifold
Tell me about it, I run a small block Chevy:
http://www.billhughes.com/JeepNOhood.jpg God Bless America, Bill O|||||||O DougW wrote: > > no no no... the distributor should be crammed up against the > firewall to provide as small a space as possible to get a > wrench on the hold down bolt while all the time having to move > parts and bits back and forth over an open carb. :] > > -- > DougW |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AWA [DEMAND] ford 4.6l intake manifold | [email protected] | General | 0 | December 27th 05 12:51 PM |
question about intake manifold & coolant | Scotter | Ford Mustang | 3 | October 22nd 05 02:10 AM |
96 Chev PU Leaking water from intake manifold?? | [email protected] | Technology | 4 | July 6th 05 02:41 PM |
QUESTION: 1996 GT Intake Manifold | EADGBE | Ford Mustang | 3 | June 26th 05 08:43 PM |
1999 3.1 intake manifold replacement questions | [email protected] | Technology | 4 | February 7th 05 09:26 PM |