If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
wiring circuit for N/S window winding motor
Hi,my first post, hope someone can help. I've just rectified a seized up
motor in the door of my Honda Civic 3 dr 1.4 P reg. From an external source the motor will operate, in both directions perfectly, but with all door connections made it will not operate. I have a feed (to) the motor from both door switches and through the windings to a cable Blu/Red that I cannot trace, it doesn't go to earth because it's live when the motor changes rotation. A wiring circuit would be a great help or maybe someone has had this problem themselves. appreciate any suggestions, thanks. Roy |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mustang power window bounce back calibration does not workwhen following owners guide. (FIX) | Thomas Hart[_1_] | Ford Mustang | 0 | January 6th 07 02:24 PM |
The engine and the electric motor | Triple-MIGHT | General | 2 | February 12th 06 08:14 AM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 5 | January 19th 06 06:15 AM |
L98: starts, but won't keep running. | Dave Gee | Corvette | 15 | October 22nd 05 08:43 PM |
Climatronic Diagnostic Controls | Luís Lourenço | Audi | 1 | November 12th 04 08:22 AM |