If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1994 Ford Ranger Clutch slipping when hot- clutch has 1000 miles on it.
Clutch rebuild kit and slave cylinder installed by Pep Boys- has 1000 miles
on it and seem too tight. Slips when hot, disenguages fine. Can I fix it myself. What is problem? Air in hydraulics? Just bought truck last week. Only true 57,000 miles! Also fuel gauge not working-no movement. Stays on E. I think they did something when replacing Clutch. Thanks |
Ads |
#2
|
|||
|
|||
1994 Ford Ranger Clutch slipping when hot- clutch has 1000 mile
could have oil on on clutch plate andclutch plate could not be seated and
also sometimes it can take about 30 or 40 normal starts to seat a new one and if pep boys install it there might be a warranty |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1988 Ford Ranger 4x4 w/3"lift , shakes and jerks in 1st gear what would cause this? | JCO | 4x4 | 0 | May 4th 04 11:44 PM |
2003 Ford Ranger problem | [email protected] | 4x4 | 0 | February 27th 04 05:08 PM |
1996 Ford Ranger 4wd problem | Tom | 4x4 | 0 | February 7th 04 05:13 PM |