If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Trim backing
My trim is still is relatively good shape. The problem is after removing
trim panels to do interior work a number of time on the 88 Fox, the corkboard has ripped up where the nylon retainers are inserted. Its no fixable. Was considering using a high density plastic sheet as a replacement for the corkboard. Suggestions welcome. -- Jonny |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2003 T&C radio trim removal | jb | Chrysler | 5 | May 19th 06 10:26 PM |
Ping:tigger | Stephen H | Honda | 9 | December 26th 05 06:28 AM |
Ping Tigger: case study on rear O2 sensor and fuel trim | Stephen H | Honda | 0 | December 24th 05 05:37 AM |
2001 300m passenger door handle(inside) | Fiberman | Chrysler | 19 | March 27th 05 08:33 PM |