If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Fuelmeister.
Article in my snail mail July 2008 Popular Science magazine, if I may
quote the article? (I am not too good at quoting, or anything else for that matter) Quote: Green DIY.Boil Up Biofuel In Your Garage.Make your bad eating habits finally pay off.The Fuelmeister II, produced by Renewal Fuels in Nevada, converts used cooking oil into clean, efficient biodiesel that will run any unmodified diesel engine.Just pour cooking oil, racing methanol, lye and tap water into the machine's mixing cone and plug it in.The closed - system refinery will brew some 43 gallons of diesel in about half an hour.At roughly 70 cents a gallon, the greasy stuff can add up to big savings and is even more cost effective if you make it in bulk to share for sale. www.fuelmeister.com Cost: $3,100 Level Of Difficulty: 7 Audacity Meter : 6 Unquote.Check the article out on page 43 in Popular Science Magazine for July 2008. cuhulin |
Ads |
#2
|
|||
|
|||
Fuelmeister.
It is easier than you might believe, and should not cost anywhere near that.
The reaction is dead simple,and the only hazardous chemical components are the lye (sodium hydroxide) and the methanol ("wood" alcohol"). Lye is also called "caustic" (soda), and is highly alkaline. Wood alcohol of course is poisonous and flammable. You simply blend these materials together at the proper ratio and stir. You can use a pump to agitate the materials. The warmer the materials, the faster the conversion, but it will work without any heat at all in a few days. After the conversion is complete, you drain the glycerine off the bottom of the tank, and use or dispose. The fuel, which contains methyl esters of fatty acids, is decanted from the upper fraction, and should be filtered before use. It is essentially that simple. I assume no responsibility for anyone's use of the above information as it is not intended to be a complete and commercial package. It is simply a transfer of general information, and the experimenter proceeds at his or her own risk. I will answer some questions, if there are any, under the same "hold harmless" conditions. > wrote in message ... > Article in my snail mail July 2008 Popular Science magazine, if I may > quote the article? (I am not too good at quoting, or anything else for > that matter) > > Quote: > Green DIY.Boil Up Biofuel In Your Garage.Make your bad eating habits > finally pay off.The Fuelmeister II, produced by Renewal Fuels in Nevada, > converts used cooking oil into clean, efficient biodiesel that will run > any unmodified diesel engine.Just pour cooking oil, racing methanol, lye > and tap water into the machine's mixing cone and plug it in.The closed > - system refinery will brew some 43 gallons of diesel in about half an > hour.At roughly 70 cents a gallon, the greasy stuff can add up to big > savings and is even more cost effective if you make it in bulk to share > for sale. www.fuelmeister.com Cost: $3,100 Level Of Difficulty: 7 > Audacity Meter : 6 > > Unquote.Check the article out on page 43 in Popular Science Magazine for > July 2008. > cuhulin > |
#4
|
|||
|
|||
Fuelmeister.
What is needed is something like a Back To The Future car.
cuhulin |
#5
|
|||
|
|||
Fuelmeister.
Paul <Houston, Texas, USA> wrote:
> >Cooking oil is bad for you. That's not what the National Trans-Fat Council says. They say that deep-fried foods made with hydrogenated soybean oil are an important part of every balanced breakfast. --scott -- "C'est un Nagra. C'est suisse, et tres, tres precis." |
#6
|
|||
|
|||
Fuelmeister.
>It is easier than you might believe, and should not cost anywhere near that.
> >The reaction is dead simple,and the only hazardous chemical components are >the lye (sodium hydroxide) and the methanol ("wood" alcohol"). Lye is also >called "caustic" (soda), and is highly alkaline. Wood alcohol of course is >poisonous >and flammable. > >You simply blend these materials together at the proper ratio and stir. You >can use a pump to agitate the materials. The warmer the materials, the >faster >the conversion, but it will work without any heat at all in a few days. > >After the conversion is complete, you drain the glycerine off the bottom of >the >tank, and use or dispose. The fuel, which contains methyl esters of fatty >acids, >is decanted from the upper fraction, and should be filtered before use. > >It is essentially that simple. > >I assume no responsibility for anyone's use of the above information as it >is not >intended to be a complete and commercial package. It is simply a transfer >of >general information, and the experimenter proceeds at his or her own risk. > >I will answer some questions, if there are any, under the same "hold >harmless" >conditions. What happens to the lye? |
#7
|
|||
|
|||
Fuelmeister.
Scott Dorsey wrote: > Paul <Houston, Texas, USA> wrote: > > > >Cooking oil is bad for you. > > That's not what the National Trans-Fat Council says. They say that deep-fried > foods made with hydrogenated soybean oil are an important part of every > balanced breakfast. But does it help you emotionally, as lard does, according to the Lard Information Council? http://farm1.static.flickr.com/141/3...627c724f_o.gif |
#8
|
|||
|
|||
Fuelmeister.
"BuckerooBilly" > wrote in message > What happens to the lye? The lye falls to the bottom with the glycerine. You only use a very small amount of the lye catalyst...less than one percent of the total oil. |
Thread Tools | |
Display Modes | |
|
|