If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
"Dave Milne" > wrote in message
. uk... > > I haven't got the rear bumper yet, so can't advise. However, I should add > that the control arm skid plates did require a bit of grinding to a > bracket > on the axle to allow the U bolt to fit. Not difficult though. > > Dave > Thanks, I'll keep that in mind. TW |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LIDAR Trial this Week | [email protected] | Driving | 17 | April 9th 06 02:44 AM |
Expert Opinion Sought | TW | Jeep | 0 | June 29th 05 09:56 AM |
HELP: Opinion Needed | Billy | Corvette | 0 | August 19th 04 08:34 PM |