If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Check Engine Light and Fuel Mixture
I have a high mileage 95 Explorer which I now only use for
biking and camping trips. These trips usually take me through the mountains of Colorado. Lately and consistently the check engine light has been going on and off as I drive through the mountains making significant elevation changes. However, once I'm at my destination or at home the light stays solid off and the engine runs smoothly. During the times the light is turning on and off the engine runs slightly rough. From what I understand the computer is making adjustments to the fuel mixture during elevation changes based on the sensor imput from the MAF in the upper intake manifold and the Hot O2 in the exhaust pipes. I think there are three Hot O2 sensors in the exhaust system. All of these sensors are the original. I'm thinking one or more of these sensors is now marginal. My question to the group is can I eliminate the on/off of the check engine light during elevation changes by changing one or more of these sensors? When the vehicle was newer the check engine light never came on. However, I can now reliably predict when the check engine light will start coming on based on where I am driving in the mountains. I know there are voltage measurements that can be made to the sensor outputs. However, when I am at home the light never comes on so I am assuming the sensor outputs are all in a normal range. Thanks in advance for any input on this subject. Mark |
Ads |
#2
|
|||
|
|||
In article >,
Mark Barrett > wrote: > My question to the group is can I eliminate the on/off of >the check engine light during elevation changes by changing one >or more of these sensors? When the vehicle was newer the check >engine light never came on. However, I can now reliably predict >when the check engine light will start coming on based on where >I am driving in the mountains. I know there are voltage measurements >that can be made to the sensor outputs. However, when I am at home >the light never comes on so I am assuming the sensor outputs are >all in a normal range. The best way to deal with this is to get the codes pulled from the computer to see why it's turning on the check engine light. I think places like Kragen or AutoZone will do this for you. Once you know what is causing the check engine light to come on, check back here and someone can probably tell you what you need to look at next. -- Mike Iglesias Email: University of California, Irvine phone: 949-824-6926 Network & Academic Computing Services FAX: 949-824-2069 |
#3
|
|||
|
|||
You might have trouble finding a place that will read the codes for a 1995.
I think it wasn't until 1997 models that the interface to read the codes conformed to the industry standard. At any rate, I took my 1995 to an autoparts store and they told me they couldn't read codes off of pre 1997 Explorers. "Mike Iglesias" > wrote in message ... > In article >, > Mark Barrett > wrote: > > My question to the group is can I eliminate the on/off of > >the check engine light during elevation changes by changing one > >or more of these sensors? When the vehicle was newer the check > >engine light never came on. However, I can now reliably predict > >when the check engine light will start coming on based on where > >I am driving in the mountains. I know there are voltage measurements > >that can be made to the sensor outputs. However, when I am at home > >the light never comes on so I am assuming the sensor outputs are > >all in a normal range. > > The best way to deal with this is to get the codes pulled from the > computer to see why it's turning on the check engine light. I think > places like Kragen or AutoZone will do this for you. Once you know > what is causing the check engine light to come on, check back here > and someone can probably tell you what you need to look at next. > > > -- > Mike Iglesias Email: > University of California, Irvine phone: 949-824-6926 > Network & Academic Computing Services FAX: 949-824-2069 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
LHS Won’t start in Cold weather and Check engine light on. | jgcurt | Chrysler | 22 | January 10th 05 07:57 PM |
rec.autos.makers.chrysler FAQ, Part 1/6 | Dr. David Zatz | Chrysler | 10 | December 18th 04 05:15 AM |
In-the-tank fuel pumps cause death and destruction | Silver Surfer | Chrysler | 293 | November 7th 04 03:41 PM |
My Beetle's Maintenance Schedule - Help Please! | Sleepy Joe | VW air cooled | 0 | October 18th 04 01:53 AM |