If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Renault Megane Cabriolet - Fitting new Hydraulic cables for electric hood
Does anyone out there know how replace the hydraulic cables that power
the hood up and down? The compressor unit is in the boot and various hydraulic cables are connected to it. I have 2 new cables (at some exhorbitant cost from Renault - 127 pounds sterling !) as one of the old cables sprung a leak. But I can't figure how to remove the old cables from the compressor unit. The other end of the cables don't present a problem as they connect to the ram with nuts. But, the compressor end is mysterious to me. Perhaps it's a simple twist that's needed with pliers but I don't want to try this and end up breaking something. By the way, the model year is 1998 and it's a 2.0 litre sports. Thanks, Shaun. |
Ads |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|