If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
What sensitivity/deadzone values to use with GTL Demo??
Hi all,
i'm using a Logi FF GP and was wondering what values you guys use to get a good feel in the GTL Demo with this wheel. I've tried lads of different values and combinations but still can't seem to quite connect to the car. Any experiences? Cheers! Cris |
Ads |
#2
|
|||
|
|||
"Cris Eichler" > wrote in
: > Hi all, > > i'm using a Logi FF GP and was wondering what values you guys use to > get a good feel in the GTL Demo with this wheel. I've tried lads of > different values and combinations but still can't seem to quite > connect to the car. Any experiences? > > Cheers! > > Cris > > > There are tons(or Tonnes if you are Euro) of posts about this topic going allll the way back to F1 2k. you can google groups ras and search for controllers and probably find out more than you'll ever want to know. Basically, if you want to match the 100% linearity of the Papy sims, then you need to set your sliders in both the logi profiler and the ISI/GTL sims to 50% Less than 50% slows down the steering some, and more than 50% begins to make it quicker, more twitchy, more nervous. Deadzones to zero. Speed Sensitivity to zero. The lower the steering lock percentage inside the setups, the slower, smoother the steering. But also, the lower you make the %, the wider your car turns...so sharp corners become a problem. 15% to 18% should suffice. dave henrie |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Car Values | Bill Berckman | VW air cooled | 35 | August 12th 05 03:45 AM |
TJ Sway Bar Link Torque Values Anyone?? | [email protected] | Jeep | 3 | March 20th 05 07:12 PM |
Odyssey Values? | [email protected] | Honda | 1 | February 21st 05 06:07 PM |
I dont get the c3 vs c4 values | Ralph | Corvette | 70 | November 25th 04 10:03 AM |