If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
New Panel! Should I strip it?
Hi All,
New front panels for my 68 bay arrived from GSF today! I have a couple of questions: 1) Should I strip the black stuff before etch primeing it or just etch prime on top? 2) Should I use the fold over flap at the bottom like 74 bay ( would it make this section stronger) or reform the kink and weld them together like the original 68 front end? I just dont know what would be best. Any ideas guys? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door stuck shut covers panel screws (how to remove?) | Stuart A. Bronstein | Technology | 0 | February 26th 06 09:07 AM |
1998 Windstar Instrument Panel Light Bulb Replacement Procedure Question | KC | Technology | 0 | February 8th 06 02:20 AM |
98 Honda Accord door panel removal??? | [email protected] | Honda | 1 | December 26th 05 04:12 PM |
Mike Romain or anyone else? Instrument Panel Grounding Screw location? | SP | Jeep | 4 | September 17th 05 01:15 PM |
2002 v6 ex sedan front speaker door panel removal ? | [email protected] | Honda | 0 | August 26th 05 09:44 PM |